TROUBLESHOOTING
5FAQ
Question
Answer
| • Check the antenna or cable connection to the main unit. | |
| • Check the batteries of the remote control. | |
| • Check if there is an obstacle between the infrared sensor window and | |
| the remote control. | |
| • Test the signal output. If OK, then possible infrared sensor trouble. | |
| (Refer to “IR Signal Check” on page 33.) | |
My remote control does not work. What | • Aim the remote control directly at the infrared sensor window on the | |
front of the unit. | ||
should I do? | ||
• Reduce the distance to the unit. | ||
| ||
| • | |
| • When there is an | |
| may interrupt the remote control signal of this unit. | |
| • Move the | |
| angle of the infrared sensor or turn off the infrared communication | |
| function. | |
How come the Initial setup appears every | • Connect the RF cable to the unit directly and run the initial setup. | |
time I turn on this unit? | • Make sure to complete the channel scan before turning off the unit. | |
| • Make sure auto channel scan has been completed. | |
| (Refer to “Auto Channel Scan” on page 13.) | |
| • Auto channel scan must be completed when you set up the unit for the | |
| first time or move it to a location where previously unavailable channels | |
| are broadcast. | |
| • The selected channel may not be broadcasting. | |
Why I cannot watch some of TV programs? | • When auto channel scan is interrupted and not completed, | |
some channels will not be received. Make sure to complete. | ||
| ||
| (Refer to “Auto Channel Scan” on page 13.) | |
| • The selected channel cannot be viewed by the | |
| (Refer to | |
| • The unit requires some kind of antenna input. An indoor antenna (rabbit | |
| ears), an external antenna, or an RF coaxial cable from your wall or cable | |
| /satellite box needs to be plugged into the unit. | |
How come there is no image from the | • Check if the right input mode is selected by pressing [INPUT SELECT] or | |
using [CH K / L ]. (Refer to “Switching Each Input Mode” on page 16.) | ||
connected external devices? | ||
• Check the antenna or cable connection to the unit. | ||
| ||
|
| |
Whenever I entered channel number, | • Many digital channels have alternate channel numbers. The unit changes | |
the numbers automatically to the ones signifying the broadcasting | ||
it changes automatically. | ||
stations. These are the numbers used for analog broadcasts. | ||
| ||
|
| |
| • Captions that are delayed a few seconds behind the actual dialogue are | |
Why are captions not displayed entirely? | common for live broadcasts. Most captioning production companies can | |
Or, captions are delayed behind the | display a dialogue to maximum of 220 words per minute. If a dialogue | |
dialogue. | exceeds that rate, selective editing is used to insure that the captions | |
| remain | |
How can I set the clock ? | • There is no clock function on this unit. | |
|
|
32
EN