OPERATION
BASIC OPERATION
SWITCHING ON/OFF THE UNIT
Press PWR button on the front panel or
POWER button on the remote control
to turn on the unit.
FACEPLATE RELEASE
Press 
button on the front panel to
detach the removable faceplate.
SOUND ADJUSTMENT
Press SEL button on the front panel of the unit or on the remote control to select the desired adjustment mode. The adjustment mode will change in the following order:
VOL 
BAS 
TRE
BAL 
FAD
(Volume) (Bass) (Treble) (Balance) (Fader)
By pressing the VOL 
/VOL
buttons on the front panel or VOLUME +/- buttons on the remote control, it is possible to adjust the desired sound quality.
LOUDNESS
Press and hold BND/LOU button on the font panel for several seconds or press LOUD button on the remote control to reinforce the bass output. Press BND/LOU button on the font panel for several seconds again or press LOUD button on the remote control again to release this function.
SET THE CLOCK
Press the DSP button on the front panel, the clock is shown on the LCD display. Then hold down the button until the clock flashes. Then press the VOL 
button on the front panel or VOLUME + button on the remote control to change hours; press VOL 
button on the front panel or VOLUME button on the remote control to change minutes.
MUTE
Press MUT button on the front panel or MUTE button on the remote control to mute down the sound instantly. Pres it again to resume sound output.
EQUALIZATION
Press EQ button shortly to turn on equalization function and to select desired audio mode. There are three kinds of mode as below:
CLAS 
POP 
ROCK
MODE SELECTION
Press MOD button on the front panel of the unit or MODE button on the remote control to select among radio, disc (DVD/VCD/CD/MP3) play mode and AV IN mode.
LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display of the front panel.
FLASHING LED
If the front panel does not install in the main unit, the LED will be flashing.
REMOTE SENSOR
Point the remote control handset to the remote sensor RX. Press the function keys on the handset to control the system.
RESET FUNCTION
RESET button on the housing must be activated with either a ballpoint pen or thin metal object. The RESET button is to be activated for the following reasons:
16