Daewoo DP-HG22 Adjusting Angles After Installation 10˚, 15˚, 20˚, HOW to Adjust Viewing Angles

Page 13

.As pictured below, pull and adjust the lever (X) to fit your desired viewing angle.

PLASMA DISPLAY HANGER UNIT

4. ADJUSTING ANGLES AFTER INSTALLATION (10˚, 15˚, 20˚)

1

2

HOW TO ADJUST VIEWING ANGLES

.Take out the screws from the upper part of the frame.

.Insert the upper part of the frame set B angle adjustment to its gap.

Lever (X)

Note

.This adjustment needs to be done when the plasma display is tightly secured. Otherwise, the unit

.can fall and break.

.Please retain the two screws for future angle adjustments.

At least two people are needed when modifying angle adjustment.

THE FIGURES BELOW DISPLAY THE POSSIBLE PLASMA DISPLAY ANGLES.

lever

H W

A A

N L

G L

E

R

U

N

I

T

0 ˚

1 0 ˚

1 5 ˚

2 0 ˚

12

Image 13

Contents DP-HG22 Plasma Monitor Display Wall Hanger UnitTable of Contents Please Check the Items Shown below Plasma Display Hanger UnitPlease Follow These Instructions for Your Safety Important Safety InstructionsWhen installing on a concrete wall Paper pattern plan To Place the Protective Caps Assembling InstructionsHOW to Install Frame SET a on the Unit Installing the Wall Frame SET a on the Plasma Display PanelAttaching Paper Pattern Plan on the Wall Installing Wall Frame SET B and Connecting FrameInstalling on the Wall Held by Supporting Wooden Structure Install the Wall Frame SET on the WallConnecting Lower Part of Frame SET a and Frame SET B To Provide the Securest FIT HOW to Adjust Viewing Angles Adjusting Angles After Installation 10˚, 15˚, 20˚