PLASMA DISPLAY HANGER UNIT
3. ASSEMBLING INSTRUCTIONS
PREPARATION
WHEN THE PLASMA DISPLAY IS ATTACHED TO THE STAND
1TO DETACH THE STAND FROM THE PLASMA DISPLAY
.To avoid unwanted marks on the unit, place a protective covering over the surface you will be working on and lay the plasma display as shown below.
.Unscrew the secured 2 screws completely and Pull the stand away from the plasma display to detach.
2TO PLACE THE PROTECTIVE CAPS
.There will be two holes where the stand has been detached.
Holes
.Put the protective caps on the holes and use the screws to secure tightly.
Caps
Screws
HW A A N L G L E
R
U
N
I
T
6