CORRIGENDA
MODEL:
.
.
.
.
.
2
INSTALLING THE WALL FRAME SET A ON THE PLASMA DISPLAY PANEL
Replace the previous instruction (#2) with the following updated one.
Four M5 screws are not used out of total number.
Make sure the installation is secure.
Installation by professional is preffered.
Contact infomation for any question.
HOW TO INSTALL FRAME SET A ON THE UNIT
.To avoid unwanted marks on the unit, place a protective covering over the surface you will be working on and lay the plasma display as shown in the picture below.
.Place frame set A on the left and right side of the unit and use the enclosed screws (M5) to secure them tightly.
(left and right 2 each)
.WhenNotesecuring frame set A to the plasma display panel, make sure that they match the holes correctly.
.If the holes are matched incorrectly, the installation will not be successful.
7