DirecTV RC65 manual Searching for TV, AV1 or AV2 Codes

7.Repeat steps 1 through 6 to set up a new component under AV2 (or AV1).

8.For future reference write down the working code for the component(s) set up under AV1 and AV2 below:

AV1:

COMPONENT: ___________________

AV2:

COMPONENT:___________________

SEARCHING FOR TV, AV1 OR AV2 CODES

If you were unable to find the code for your brand of TV or component, you can try a code search. This process may take up to 30 minutes.

1.Turn on the TV or component. Insert a tape or disk if applicable.

2.Slide the MODE switch to the TV, AV1 or AV2 position, as desired.

3.Press and hold the MUTE and SELECT keys at the same time until the green light under the selected switch position flashes twice, then release both keys.

4.Enter 9-9-1followed by one of the following four- digits:

COMPONENT TYPE	COMPONENT ID #
Satellite	0
TV	1
VCR/DVD/PVR	2
Stereo	3

5.Press PWR, or other functions (e.g. PLAY for VCR) you want to use.

6.Point the remote at the TV or component and press CHANS. Repeatedly press CHANSuntil the TV or component turns off or performs the action you selected in step 5.

NOTE: Every time CHANSis pressed the remote advances to the next code and power is trans- mitted to the component.

10