3.Using the number keys, enter
4.Press and release the SELECT key. (The green light flashes twice.)
NOTE: DIRECTV® Receivers don’t have volume control, so the remote will not allow the user to lock vol- ume to the DIRECTV mode.
RESTORING FACTORY DEFAULT SETTINGS
To reset all the functions of the remote control to the factory defaults (the original,
1.Press and hold the MUTE and SELECT keys at the same time until the green light flashes twice, then release both keys.
2.Using the number keys, enter
TROUBLESHOOTING
PROBLEM: Light at the top of the remote blinks when you press a key, but the component does not respond.
SOLUTION 1: Try replacing the batteries (see page 7).
SOLUTION 2: Make sure you are aiming the DIRECTV® Universal Remote Control at your home entertainment component and that you are within 15 feet of the component you are trying to control.
PROBLEM: The DIRECTV Universal Remote Control does not control component or commands are not recognized properly.
SOLUTION: Try all listed codes for the device brand being set up. Make sure all components can be operated with an infrared remote control.
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo units may require both a TV code and a VCR code for full operation (see page 8).
PROBLEM: CHANS, CHANT, and PREV do not work for
your RCA TV.
SOLUTION: Due to RCA design for certain models (1983- 1987), only the original remote control will operate these functions.
PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required pressing ENTER to change channels, press ENTER on the DIRECTV Universal remote control after entering a channel number.
PROBLEM: Remote control does not turn on Sony or Sharp TV/ VCR Combo.
SOLUTION: For power on, these products require setting up TV codes on the remote control. For Sony, use TV code 10000 and VCR code 20032. For Sharp, use TV code 10093 and VCR code 20048. (See “Controlling Other Components” on page 9.)
12