5.All of the screws are properly torqued to specification when the unit is assembled at the factory and should not need an further initial adjustments. However, due to the variety in size of different monitors, MINOR adjustment may be required to optimize the tension needed for ease of movement. Be sure that your monitor is supported properly while making ANY changes to the cantilever. To loosen or tighten the 4 screws respectfully on the back of the rear pivot clamp until the desired tension is obtained (see image 2 – Tilt Tensioning Screws and Image 3 – Tensioning Tilt). It is important to try to maintain even torque on
each of the 4 screws. It does not take that much change in torque to make a large difference in the tilt tension. To loosen or tighten the swing arm tension use the supplied 5/32 inch hex wrench to loosen or tighten the screw shown in image 2 & 3 (Swing Arm Tensioning Screw). Periodic adjustment of these screws may be necessary to maintain desired tension. There should be NO reason to tighten or loosen the wrist hinge bracket. You should need to tighten or loosen the shoulder hinges screws (located top and bottom of hinge), improper tightening of these screws can damage the shoulder hinge bracket and the wall mount plate.
P-150 Cantilever Mount Installation Instructions
z125 lb maximum weight capacity
zCantilever arm mount for large plasma panels
zAllows maximum flexibility for installing and viewing
displays
z Horizontal leveling adjustment (20 range, 10)
zCantilever arm provides full extension and 180 of lateral rotation for viewing from multiple locations.
zNesting arm design allows display to be folded parallel to wall
zProvides full tilt and swivel capabilities for optimum viewing
zQuick mount capability with Plad
zDurable grey or black powder coat finish.
Check the Hare Ware Kit after open the package
Description | Quantity |
|
|
3/16 inch Hex Wrench | 1 |
|
|
5/32 inch Hex Wrench | 1 |
|
|
7/32 inch Hex Wrench | 1 |
|
|
3/8 x | 6 |
|
|
3/8ID x 13/16OD Washer | 6 |
|
|
Button Head Screw | 4 |
|
|
Nylon jam nut | 4 |
|
|
Read through the entire instruction manual before beginning.