Mounting the Wall Plate Mounting to Wooden Stud

Mounting the Wall Plate

Mounting to Wooden Stud

1.Determine the location where you want the display mounted on the wall.

2.USE stud finder to locate and mark the center of the two studs.

3.Remove P-150 from box. Remove the PA-4260 Adaptor plate from the Mounting Head, and set the four 3/8-16 button head screws aside for later.

4.Remove the cantilever arm from Wall Plate

5.Align center mounting holes of wall plate with center marks on studs. Using the wall plate as a template, mark the mounting holes and center J box hole. Install J box as required.

Note: Electrical outlets should only be installed by a qualified electrician.

6.Drill mounting holes with 9/32 inch bit. Mounting holes should be 3 inch (76mm) deep.

Mounting to Masonry

1.Using the wall plate as a template, mark the mounting holes in the desired mounting location.

2.Drill mounting holes with 3/8”(10mm) masonry bit. Mounting holes should be a minimum of 2-9/16”(65mm) deep.

3.Insert masonry mounting anchors (not supplied) into holes, and tap flash with hammer.

DCS Flat Panel TV warranty Mounting the Wall Plate Mounting to Wooden Stud, Mounting to Masonry