DCS Flat Panel TV warranty Set PA-4260 width, Standard Configuration, Narrow Configuration

Set PA-4260 width

The PA-4260 is capable of handling a wide range of landed insert widths. Measure the horizontal distance between mounting lands on your display, and set the width of the Mounting Rails as shown, Standard Range: 38 1/2”(98 cm) to 15 3/4”(40 cm)

Standard Configuration

For standard range configurations, loosen the screws on the sliders using the supplied Hex Wrench; adjust rails to desired width, and then re-tighten screws.

Narrow Range: 15 1/2”(39 cm) to 3 1/2”(9 cm)

Narrow Configuration

For narrow range configurations, flip slider/rail assembly over (as shown below) before inserting them into the channels.

Secure Sliders and back plate

Secure sliders with (8) button head screws. For medium and narrow displays, where the nuts on the slider are beneath the back plate, thread button head screws through the back plate and into the slider as shown.

Note: The outer corners of the back plate must always be secured with a screw. For wide displays, where the nuts on the slider are positioned outside of the back plate, use Nylon jam nuts with button head screws (supplied) to secure the back plate, as shown.