Mount PA-4260 to Display Hardware Selection

Mount PA-4260 to Display

a.Consult the supplied Hardware Cross Reference list.

b.Select the mounting hardware for your display.

a.Position the PA-4260 over back of display.

b.Thread mounting screws through square washers and spacers (if required), as shown.

c.Thread mounting screws through slots on side rails into landed inserts, and secure loosely.

d.With mounting screws installed, center PA-4260 on the back of the display, and then tighten all screw securely.

CAUTION: Do not use power tools or over-tighten the mounting screws.

1.Remove slider retaining screws as shown.

2.Remove sliders from channels.

3.Select required side size: Medium rail- up to 17 1/8”height of landed inserts Large rail- up to 25” height of landed inserts.

4.Attach selected side rails to sliders as shown.

5.Re-install slider assemblies into channels as shown, and return to Set PA-4260 Width section.