Xantech manual ISM4 INSTALLATION & PROGRAMMING MANUAL

ISM4 INSTALLATION & PROGRAMMING MANUAL 17

Figure 8 ISM4 Expansion Connections

1.Using a 1-Foot Mono Cable (Xantech Part No 6017400), connect the Expansion Jack on the Primary ISM4 to the Source 1 “Sense In” on the First Expansion ISM4.

2.If using additional ISM4s, repeat Step 1 for each additional ISM4 as shown in Figure 8.

3.Connect the included Power Supplies, one to each ISM4.

4.Connect the Sensors and Emitters as described the Sections: Connections/Home Theater System or Connections/Multi-Zone System.

NOTE 1: The Source 1 “Sense In” on the ISM4 Expansion units is used for System Status as referenced to the System Reference Device. There is no required IR Emitter connection to the Source 1 IR Outs on the ISM4 Expansion units.

NOTE 2: If using the Expanded application with a multi-zone controller, there would be no required IR Emitter connection to the Primary ISM4 Source 1 “IR Out “as shown in Figure 8.