ISM4 INSTALLATION & PROGRAMMING MANUAL | 32 | |
NEXT | Not used in this IR Learn Mode. |
|
PREV | If not save of any learned IR is desired, press to return to Edit Mode. |
|
Delay Program Mode
Press the Front Panel Buttons and observe the LED’s to program Delays in Command Structures as follows: NOTE: Upon entering Delay Edit Mode, the Delay Value is reset to 0 seconds.
| Figure 12 Front Panel Navigation – Delay Program Mode |
DELAY | Not used in this Delay Program Mode. |
NEXT | In Delay Program Mode each press will increase the amount of delay by one second from |
| seconds. After 60 seconds a press of the Next Button will set the delay to 0 seconds. |
PREV | In Delay Program Mode each press will decrease the amount of delay by one second from 0 to |
| 60 and down to 0 second. After 0 seconds a press of the Prev Button will set the delay to 60 |
| seconds. |
TEST | After a delay duration has been selected, but not saved, a press of the Test Button will initiate the |
| delay. The currently selected Source LED will flash the number of times equal to the duration of |
| the delay. |
DELETE | Press to remove delay value in the currently selected Command Structure. |
SEQUENCE | Press to save a delay to a Command Structure. This action will automatically exit IR Learn Mode |
| and enter Edit Mode. Recall that full navigation on a Command Structure and Macro level is |
| permissible in Edit Mode. |