English
Thank you for choosing SANYO. Please read all
instructions to obtain maximum benefit of your product.
|
|
|
|
| CAUTION |
| THIS SYMBOL INDICATES THAT DANGEROUS |
| RISK OF ELECTRIC SHOCK DO NOT OPEN |
| VOLTAGE CONSTITUTING A RISK OF ELECTRIC |
|
| SHOCK IS PRESENT WITH THIS UNIT. | |
|
|
|
|
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, | THIS SYMBOL INDICATES THAT THERE ARE | ||
DO NOT REMOVE COVER (OR BACK) . NO USER - | IMPORTANT OPERATING AND MAINTENANCE | ||
SERVICEABLE PARTS INSIDE. REFER SERVICING TO | INSTRUCTIONS IN THE OWNER’S MANUAL WITH | ||
QUALIFIED SERVICE PERSONNEL. | THIS UNIT. | ||
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT SAFETY INSTRUCTIONS
1.Read these instructions.
2.Keep these instructions.
3.Heed all warnings.
4.Follow all instructions.
5.Do not use this apparatus near water.
6.Clean only with a dry cloth.
7.Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
9.Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and at the point where they exit from the apparatus.
11.Only use the attachments/accessories specified by the manufacturer.
12.Use only with the cart, stand, tripod, bracket or table
specified by the manufacturer or sold with the apparatus. When a cart is used,
use caution when moving the cart/ appliance combination to avoid injury from
13. Unplug this apparatus during lightning 
storms or when unused for long periods of time.
14.Refer all servicing to qualified service personnel. Servicing is required when the appliance has been damaged in any way, such as when a
15.If an outside antenna is connected to the television equipment, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. In the U.S. Selection
16.An outside antenna system should not be located in the
vicinity of overhead power lines or other electrical light or power circuits or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.
EXAMPLE OF ANTENNA GROUNDING ACCORDING TO NATIONAL ELECTRICAL CODE, ANSI/NFPA 70
| ANTENNA LEAD IN WIRE |
| ANTENNA DISCHARGE UNIT |
GROUND CLAMP | (NEC SECTION |
| GROUNDING CONDUCTORS |
| (NEC SECTION |
GROUND CLAMPS | POWER SERVICE GROUNDING |
ELECTRODE SYSTEM | |
NEC- NATIONAL ELECTRICAL CODE | NEC ART 250, PART H) |
|
"Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article
17.Wall or Ceiling Mounting - The product should be mounted to a wall or ceiling only as recommended by the manufacturer and listed by an independent laboratory (such as UL).
18.Apparatus shall not be exposed to dripping or splashing and no objects filled with liquides, such as vases, shall be placed on the apparatus.
19.When the MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.
20.Install the LCD TV in a proper position. If not, it may result in a fire hazard.
21.Provide appropriate space on the top, sides and rear of the LCD TV cabinet for allowing air circulation and cooling the LCD TV.
22.Minimum clearance must be maintained. If the LCD TV is to be built into a compartment or similarly enclosed, the minimum distances must be maintained. Do not cover the ventilation slot on the LCD TV. Heat
2