Sanyo DP42410 manual PC Connections, PC Monitor Operation

PC CONNECTIONS

NOTE: Before connecting any cables, disconnect the AC Power Cords of both the HDTV and Personal Computer from the AC outlets.

1 Connect an RGB cable from the monitor output on your PC to the RGB connector on the HDTV and tighten the screws. (Monitor Cable not supplied).

2 Insert one end of a Stereo Mini-Audio cable into the PC Audio Out jack and the other end into the HDTV PC AUDIO INPUT jack. (Stereo Mini-Audio Cable not supplied).

HINT: Volume can be adjusted both from the PC and the HDTV VOLUME +, and - buttons.

3 Select Auto Adjustment from the PC Setup Menu.

NOTE: Power on the HDTV and any other peripheral equipment before powering on the computer.

PC MENU NAVIGATION MAP

PC MONITOR OPERATION

PC PREPARATION

To avoid a “No Support” condition, preset your PC’s output resolution to an XGA value, such as, 1024 x 768, before you disconnect it from your regular monitor.

PC MENU- AUTO ADJUSTMENTS OPERATION

1 Use the CURSOR Ÿ(UP) and ź(Down) buttons on the remote control to highlight the Auto Adjust in the PC menu mode. Press the OK button.

2 Highlight Auto Adjust and press the OK button to start the automatically adjust function.

PC MENU- MANUAL ADJUSTMENTS OPERATION

The Clock, Phase, Horizontal Position, and Vertical Position are set automatically when Auto Adjustment is completely done.

Clock- Adjust the Dot frequency to match the dot frequency of your computer.

Phase- Adjust the phase when the picture appears to flicker or blur.

H-Position- Move the image horizontally. V-Position- Move the image vertically.

1 Use the CURSOR Ÿ(UP) and ź(Down) buttons on the remote control to highlight H-Position, V-Position, Clock or Phase. Press the OK button.

2 Use the CURSOR ŻŹ XWWRQVWR GMXVWWKH setting value. Press the MENU button to return.

3 Press the EXIT button on the remote control to exit the current menu.

PC MENU OPERATING TIPS

The Picture settings in the PC input do not affect other input settings.

English

13