Sanyo DP32D13 manual Important Safety Instructions, Do not Open

Page 2

ENGLISH

Thank you for choosing SANYO. Please read all

instructions to obtain maximum benefit of your product.

 

 

 

THIS SYMBOL INDICATES THAT DANGEROUS

 

CAUTION

 

 

 

VOLTAGE CONSTITUTING A RISK OF ELECTRIC

 

RISK OF ELECTRIC SHOCK

 

 

 

SHOCK IS PRESENT WITH THIS UNIT.

 

DO NOT OPEN

 

 

 

 

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO

THIS SYMBOL INDICATES THAT THERE ARE

NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE

IMPORTANT OPERATING AND MAINTENANCE

PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE

INSTRUCTIONS IN THE OWNER’S MANUAL WITH

PERSONNEL.

THIS UNIT.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

Important Safety Instructions

1.Read these instructions.

2.Keep these instructions.

3.Heed all warnings.

4.Follow all instructions.

5.Do not use this apparatus near water.

6.Clean only with dry cloth.

7.Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.

8.Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.

9.Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10.Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and at the point where they exit from the apparatus.

11.Only use attachments/accessories specified by the manufacturer.

12.Use only with the cart, stand, tripod, bracket

or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/appliance combination to avoid injury from tip-over.

13.Unplug this apparatus during lightning storms or when unused for long periods of time.

14.Refer all servicing to qualified service personnel. Servicing is required when the appliance has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped.

15.If an outside antenna is connected to the television equipment, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges.

In the U.S. Selection 810-21 of the National Electrical Code provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrodes.

16.An outside antenna system should not be located in the vicinity of overhead power lines or other electrical light or power circuits

or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

EXAMPLE OF ANTENNA GROUNDING ACCORDING TO NATIONAL ELECTRICAL CODE, ANSI/NFPA 70

Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

17.Wall or Ceiling Mounting - The product should be mounted to a wall or ceiling only as recommended by the manufacturer and listed by an independent laboratory (such as UL).

18.Apparatus shall not be exposed to dripping or splashing and no objects filled with liquides, such as vases, shall be placed on the apparatus.

19.When the MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.

20.Install the LCD TV in a proper position. If not, it may result in a fire hazard.

21.Provide appropriate space on the top, sides and rear of the LCD TV cabinet for allowing air circulation and cooling the LCD TV.

22.Minimum clearance must be maintained. If the LCD TV is to be built into a compartment or similarly enclosed, the minimum distances must be maintained. Do not cover the ventilation slot on the LCD TV. Heat build-up can reduce the service life of your LCD TV, and can also be dangerous.

2

Need help?

www.sanyoctv.com

1-800-877-5032

Image 2
Contents 32 LED Important Safety Instructions Do not OpenCanadian Notice Handling PrecautionsFCC Information Energy Star User InformationContents Positioning the TV InstallationAccessories Screw type Installing StandWall Mounting Optional Antenna Connection for Off-air Signals Install Batteries in the Remote ControlOperating Range of the Remote Control Getting StartedHdmi HDMI1/DVI, HDMI2, HDMI3 Connect your Hdmi devices Controls and JacksVOL Wireless Remote Control Volume UP / Down VOLComponent YPbPr Connection ConnectionHdmi to Hdmi Connection Digital Audio Connection Video Connection Shared With Component-YPC Connection DVI to Hdmi ConnectionUSB Connection Initial SetupPower Connection Press Enter button to start the channel scan OSD Menu Operation Video MenuAudio Menu Channels Menu ‰‰ Menu Language Setup Menu‰‰ Demo Mode ‰‰ Parental ControlsTo control while in full-screen photo show Photos MenuTo control while in photo folder To control while in photo slideshowProblems and Solutions Specifications Freq. KHz Clock MHz ResolutionSupported Timing Table ONE-YEAR Limited Parts and Labor Warranty For customer assistance, call toll freeSanyo Manufacturing Corp Sanyo Road, Forrest City, AR