Sanyo DP19649, DP26649 Stand Removal and Wall Mounting Optional, Getting Started, Important Note

STAND REMOVAL AND WALL MOUNTING (OPTIONAL)

Tools Needed: Phillips screwdriver

IMPORTANT NOTE:

Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish. Wall mounting of the HDTV must be performed by a skilled person.

DP19649DP26649

1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.

2Use the screws you removed when dettach- ing the stand to secure the HDTV to a wall mounting kit (not included.)

VESA standard interface: 100 x 100

Mounting screws measurements:

M4 (4mm) Diameter, Length—10mm (maximum)

GETTING STARTED

Install batteries in the remote control

(2 “AA”, not included)

PRECAUTIONS

To ensure safe operation, please observe the following precautions:

•Replace both batteries at the same time. Do not use a new battery with a used battery.

•There’s a risk of explosion if a battery is replaced by an incorrect type.

•Do not expose the Remote Control unit to moisture or heat.

•Be sure to match the “+” and “–”signs on the batteries with marks inside the remote control.

Need help?

1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.

2Use the screws you removed when detach- ing the stand to secure the HDTV to a wall mounting kit (not included.)

VESA standard interface: 200 x 200

Mounting screws measurements:

M6 (6mm) Diameter, Length—16mm (maximum)

ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE

ANTENNA

ANALOG / DIGITAL

ANTENNA IN

CABLE

NOTE: The tuner in this HDTV can receive digital and analog off air signals from an antenna. It can also receive analog or ClearQAM cable channels from a direct Cable TV connection.

www.sanyoctv.com 1-800-877-50325