GB | SAFETY PRECAUTIONS | GB |
CAUTION: Please read and retain for your safety. This unit has been designed and manufactured to assure your personal safety, but LPSURSHUXVHFDQUHVXOWLQSRWHQWLDOHOHFWULFVKRFNRU¿UHKD]DUGV,QRUGHUQRWWRGHIHDWWKHVDIHJXDUGVLQFRUSRUDWHGLQWKLVPRQLWRUREVHUYHWKH following basic rules for its installation, use and servicing.
Installation and Use
Do not allow anything to rest on the power cord. Do not locate this LCD monitor where the
FRUGZLOOEHGDPDJHGE\SHRSOHZDONLQJRQLW
Do not overload wall outlets and extension
FRUGVDVWKLVFDQUHVXOWLQ¿UHRUHOHFWULFVKRFN
$VXLWDEOHVRFNHWRXWOHWPXVWEHSURYLGHGQHDU to the monitor and shall be easily accessible. Do not place this LCD monitor near any heat
sources such as radiators, heaters, stoves and other
Do not place your LCD monitor on an unstable stand, shelf or table. Serious injury to an individual, and damage to the LCD monitor may result if it should fall. Your sales person can recommend an approved ZDOOPRXQWLQJNLW$VSHFLDOZDOOPRXQWLQJNLWLVDYDLODEOHIRUWKLV model.
This LCD monitor should be operated only from the type of power source indicated on the monitor or as indicated in the Operating In- structions. If you are not sure of the type of power supply, consult your sales person or your local power company.
For added protection it is strongly recommended that this LCD monitor has its mains supplied via an approved earth fault protection device.
WARNING: To prevent injury the LCD monitor must be securely attached to the wall in accordance with the manufacturers installation instructions.
IMPORTANT:
This product must be earthed.
This unit is not disconnected from the mains unless the mains lead
LVXQSOXJJHG7KHLQVWDOOHUPXVWPDNHVXUHWKDWWKHZDWHUSURRILQOLQH coupler is easily accessible.
(CE42LH2WP model only)
This monitor is tested to IP66 standard rating.
This monitor is not protected against temporary or continuous immersion in liquid.
Do not use immediately after moving the LCD monitor from a low temperature to a high temperature environment, as this causes con- GHQVDWLRQZKLFKPD\UHVXOWLQ¿UHHOHFWULFVKRFNRURWKHUKD]DUGV %HIRUHFOHDQLQJXQSOXJWKHPRQLWRUIURPWKHZDOOVRFNHW
Do notPRXQWQHDUDQRSHQÀDPHVRXUFH2SHQÀDPHVPXVWQHYHU be used near this LCD monitor.
This LCD monitor should not be built in or enclosed in any way, heat build up will reduce the life of the monitor.
This LCD monitor should have a minimum distance of 5cm away from the wall and the monitor should have 10cm distance around the top and sides. AlwaysPRXQWXVLQJUHFRPPHQGHGDQGVXEVWDQWLDO¿[WXUHVDQG¿W- tings.
10cm
5cm
|
|
|
|
|
|
10cm | 10cm | ||||
7KHUHDU¿QQHGVHFWLRQDURXQGWKHFDELQHWIXQFWLRQVDVDKHDWVLQN removing heat away from the monitor. The external surface of the FDELQHW ¿QQHGDUHD PXVWQRWEHFRYHUHGRUWKHDLUÀRZUHVWULFWHGLQ
anyway by enclosing the LCD monitor.
(CE42LH2WP model only)
The operating temperature range of this monitor is guaranteed 0°C
~40°C/32°F ~ 104°F. It is not recommended to install the screen in direct sunlight without adequate shading, as this will cause the
WHPSHUDWXUHRIWKHSDQHOWRULVHDERYHWKHPD[LPXPVSHFL¿HG'R- LQJVRPD\FDXVHDEODFNVKDGRZWRDSSHDURQWKHVFUHHQZKLFK will disappear when the screen temperature returns to within the
VSHFL¿FDWLRQ7KLV³RIFRXUVH´GRHVQRWSURGXFHDQ\KDUPIXOHIIHFW on the lifetime of the monitor.
Do not apply liquid cleaners or aerosol cleaners directly onto the LCD monitor. Use a damp cloth for cleaning.
ADDITIONAL FOR NORTH AMERICA AND CANADA:
This monitor must NOT be permanently mounted to the building structure. It must be mounted in such a way that it can be removed using basic tools.
The power supply cord must NOT be attached to the building surface. The power supply cord must NOT be routed through walls, ceiling,
ÀRRUVRURWKHUVLPLODURSHQLQJVLQWKHEXLOGLQJVWUXFWXUH
The power supply cord MUST be positioned so as to prevent physical damage.
Important: (UK only)
THIS PRODUCT MUST BE EARTHED. 7KLVHTXLSPHQWLV¿WWHGZLWKDQDSSURYHGPDLQVOHDGDQGDQ approved non rewireable UK mains plug. To change a fuse in this type of plug proceed as follows:
1.Remove the fuse cover and fuse.
2.Fit a new fuse which should be a BS1362 13 Amp A.S.T.A. or BSI approved type.
3.(QVXUHWKDWWKHIXVHFRYHULVFRUUHFWO\UH¿WWHG
If the fuse cover is lost or damaged the plug must NOT be used but replaced with a serviceable plug. ,IWKH¿WWHGSOXJLVQRWVXLWDEOHIRU\RXUVRFNHWRXWOHWVLWVKRXOGEH FXWRIIDQGDQDSSURSULDWHSOXJ¿WWHGLQLWVSODFH,IWKHPDLQVSOXJ contains a fuse, this should have a rating of 13 Amp, ensure the IXVHFRYHULVFRUUHFWO\¿WWHG,IDSOXJZLWKRXWDIXVHLVXVHGWKH fuse at the distribution board should not be greater than 13 Amp.
Note: The severed plug must be destroyed to avoid a possible VKRFNKD]DUGVKRXOGLWEHLQVHUWHGLQWRD$PSVRFNHWHOVH- where.
The wires in this mains lead are coloured in accordance with the following code:
Blue 
Neutral
Brown 
Live
Green and Yellow 
Earth
1.The Blue wire must be connected to the terminal which is
PDUNHGZLWKWKHOHWWHU³1´RUFRORXUHG%/$&.
2.The Brown wire must be connected to the terminal with the letter “L” or coloured RED.
3.The Green and Yellow wire must be connected to the terminal
ZKLFKLVPDUNHGZLWKWKHOHWWHU³(´RUFRORXUHG*5((1RU
GREEN and YELLOW.
%HIRUHUHSODFLQJWKHSOXJFRYHUPDNHFHUWDLQWKDWWKHFRUGJULSLV clamped over the sheath of the lead - not simply over the wires.
Do not attempt to bypass the safety purpose of the grounding type plug.
THIS UNIT IS NOT DISCONNECTED FROM THE MAINS UN- LESS THE MAINS LEAD IS UNPLUGGED.
THE INSTALLER MUST MAKE SURE THE MAINS LEAD IS EASILY ACCESSIBLE.
3