Dish Network DISH 625 manual Connecting the Receiver to the TVs in Another Rooms

Connecting the Receiver to the TV(s) in Another Room(s)

8.Connect CH 21-69 OUT on the receiver to your existing wall cable outlet using a coaxial cable.

Note: If you do not have an existing in-home cable system, you will need to run coaxial cable to each TV in other rooms. If this is too difficult, you may want to contact a professional to do this installation.

9.Place the yellow sticker on the CH 21-69 OUT cable near where the cable attaches to the receiver. The stickers are located inside the front cover of this guide.

10.Turn on the nearby TV (the TV that gets programming from the TV1 outputs).

11.Make sure the receiver's green TV1 indicator is on.

12.Select the Modulator Setup (MENU 6-1-5).

With the Modulator Setup screen displayed on the nearby TV, use Remote

Control 1 to do the following:

a.Under TV2 Out, select either Air (for off-air channel numbers) or Cable (for cable channel numbers) based on what you wrote down in step 5.

b.Under TV2 Out, use the UP and DOWN ARROWS to change the modulator channel to the one you wrote in step 5.

c.Select Done.

14.For some TVs, you must run a channel scan so that the TVs will find and display the selected channel from the receiver. Run channel scan on all remote TV(s), if available. See your TV user’s guide for instructions.

15.Confirm that you see a picture from the receiver TV2 output on your remote TV(s).

• If your picture looks good, go to step 23.

• If your TV(s) do not have a picture or if it is not as clear as you would like it to be, go to the next step.

Page 33