Connecting the Receiver to the TV(s) in Another Room(s)
23.If desired to remind you of which TV channel your satellite programming is on, write the channel number you wrote in step 4 on a blank channel sticker and place it on or near your remote TV(s). The stickers are inside the front cover of this guide.
24.Confirm Remote Control 2 controls the receiver. See the next section for instructions.
25.Program Remote Control 2’s RECOVER to the channel you selected in step 5. See page 36 for instructions.
Confirming Remote Control 2 Operation
After the remote TV(s) have been connected to the CH
1.Press the SAT button to put Remote Control 2 in SAT mode to control the satellite receiver.
2.From a remote TV, use the Remote Control 2 arrow keys to move around the Point Dish screen. If you are able to move around in the Point Dish screen, you confirmed that Remote Control 2 is controlling the receiver.
Programming the Recover Button for a Remote TV
Now that the channel for the CH
1.Program Remote Control 2 to control your TV using the instructions in Control Other Devices with the Remote Controls on page 106.
2.Press and hold the TV mode button until all the other mode buttons light up, and then let go of the button. The TV mode button flashes.
3.Press the STAR (*) button.
4.Enter the three digits of your channel number. For example, if your remote TV is set to channel 60, enter
5.Press the POUND (#) button. The TV mode button flashes three times.
Tip: In Dual Mode, Remote Control 1 is used to control TV1 menus on the nearby TV. Remote Control 2 is used to control TV2 menus on the remote TV(s).
Page 35