Changing the TV1 and TV2 Output Channels

The receiver comes preset to use channel 3 for TV1 and off-air channel 60 for TV2. If you are experiencing interference on the channels you are using, follow these instructions to change the channel that TV1 or TV2 uses.

Make sure you are familiar with how to change channels on your TV and if necessary how to switch your TV between off-air and cable channels. When you change these receiver output channels, you must also change the channels on your TV(s) to tune to these channels to see the video from the receiver. See your TV user guide for instructions.

1. Press MENU-6-1-5to open the Modulator Setup screen.

2.For TV 1 Out, highlight the number under TV 1 Out. For TV 2 Out, skip to step 4.

3.Use the UP and DOWN ARROW buttons to change the modulator channel either 3 or 4. Continue to the next step to set TV 2 Out or skip to step 7 if you are finished making changes.

4.For TV 2 Out, select either Air (for off-air channel numbers) or Cable (for cable channel numbers).

5.Highlight the number under TV 2 Out.

6.Use the UP and DOWN ARROW buttons to change the modulator channel to one of the following:

•Air Mode - Select a channel between 21 and 69.

•Cable Mode - Select a channel between 73 and 125.

7.Select Done to save the changes.

8.Change the channel on your TV(s) to match the channel(s) you selected.

9.If desired to remind you of which TV channel to tune to get satellite programming, place a channel sticker near or on your TV to indicate the correct channel.

10.If you changed your TV 2 Out channel, repeat Programming the Recover Button for a Remote TV on page 35.

Tip: It’s easier to set the output channel from the opposite TV. For example, if you are changing the out- put on TV1 (nearby TV), use TV2 (remote TV) to make the change. When you save the changes, simply remember to change the chan- nel on the nearby TV.

Tip: The channel stickers are located inside the front cover of this guide.

Page 37