Setting Up TV1 to Operate in IR
Setting Up TV1 to Operate in IR
The following instructions describe how to set up TV1 to operate in IR only.
1.Perform the following with an existing remote control:
a.Open the TV1 UHF Pro Setup screen by pressing
b.Select Disable from the TV1 UHF Pro Setup screen.
c.Select System Info to open the System Information screen.
2.Perform the following with an IR remote control, such as a Remote Control 5.0 (as shown on the back of the remote), that you intend to use to control TV1:
a.Press the RECORD button. The Done button should be highlighted.
b.Make sure the System Information screen shows that the Primary Remote Address shows 
IR.
Page 47