Initial Settings
When the TV set is operated for the first time, the IDTV turns on first.
Because this is the first time the TV is used, there are no channels stored in the memory.
When the TV is turned on for the first time, the menu for the language selection appears on the screen. The message “Welcome please select your language!” is displayed in all language options sequentially in the OSD.
By pressing the “
” or “
” buttons highlight the language you want to set and press OK button. After then, “First time installation” OSD will appear on the screen. By pressing “
” or “
” buttons, select the country you want to set and press OK button. button (** for EU countries).
Note: Country selection OSD will not be available for UK.
After then, the active antenna selection OSD appears on the screen:
By pressing “left cursor ikonu ” or “right cursor ikonu” buttons, set active antenna mode as on or off.
If an active antenna is connected to your TV, you can select this option as On. Antenna power should be “Off” when standard antenna is used instead of the active antenna. See Configuration Menu in the following sections for more information.
Press OK button on the remote control to continue and the following message will be displayed on the screen:
To start installation process, select “Yes”, to cancel select “No”.
•To select the “Yes” or “No” option, highlight the item by using “
” or “
” buttons and press the OK button.
The IDTV will automatically tune to the UHF or VHF (** for EU countries) transmission channels, searching for digital terrestrial TV broadcasts and displaying the names of channels found. This process will take about a few minutes. To cancel searching, you can press the “M” button at any time during the process.
After Automatic Search is completed, the following message asking for analogue channel search appears on the screen:
To search for analogue channels, select “Yes”. TV switches to the analogue TV mode. The menu below is displayed to search for analogue channels:
Select your Country, Language and Text language by using “
” or “
” and “
” or “
” buttons. Press OK or RED button to continue. To cancel, press the BLUE button.
For more information on this process, see “Install Menu” section.
Note: For proper functioning of digital teletext in DTV mode, you should set country as UK in analogue AUTO PROGRAM (for UK only).