watching supports Dolby Digital, you can turn this setting on.
Note:
When you want to enjoy the Dolby Digital function, please connect the SPDIF compatible device to your TV.
Refer to Page 16 and set function SPDIF OUT in
your TV Menu to ON.
Hard of Hearing (* for EU countries only)
Use “
” or “
” button to select Hard of Hearing and then press “
” or “
” button to set this setting as On or Off.
If the broadcaster enables any special signal concerning the audio, you can set this setting as On to receive such signals.
Favourite Mode
Use this function to enable or disable favourite mode. Press “
” / “
” button to set this function as on or off.
Channel List
Use “
” or “
” buttons to go to Channel List option. Use “
” or “
” buttons to toggle Channel List Mode. If you select “TV Only”, with the “
”or “
” buttons, you navigate through only TV channels. If you select “Radio Only”, with the “
” or “
” buttons, you navigate through only radio channels. If you select “Text Only”, with the “
” or “
” buttons, you navigate through only text channels. To save the recent changes and exit; press the “MENU” button.
Active Antenna
Use “
” or “
” buttons to highlight Active Antenna option.
When antenna power option is set as On by pressing “
” or “
” button, +5V will be transmitted to the antenna output.
This feature enables the use of active antenna.
Note: Antenna power should be “Off” when standard antenna is used instead of the active antenna.
Scan Encrypted (**)
(**) For UK only.
Scan Encrypted Channel feature will always be ON after performing first time installation. When this setting is on, search process will locate the encrypted channels as well. If it is set as OFF
manually, encrypted channels will not be located while in automatic search or manual search.
Use “
” or “
” button to select Scan Encrypted and then press “
” or “
” button to set this setting as On or Off.
Receiver Upgrade
Over Air Download (OAD)
To ensure that your TV always has the most update information, use this setting. Please ensure that the TV is set to standby mode. The TV automatically powers up at 3.00 A.M. each day and searches for any new information which may be broadcast and will download this to your receiver automatically. This operation will normally take approximately 30 minutes. If you have an important recording to be carried out at 3.00 A.M. and you do not want to interrupt it, disable auto OAD search by performing the following:
•Press “M” button and using the “
” or “
” buttons to choose Setup and press the OK button.
•Highlight Configuration menu with “
” or “
” keys and press OK.
•Use “
” or “
” buttons to choose “RECEIVER UPGRADE” and press OK button.
•Using the“
” or “
” button change “Automatic scanning” from Enabled to Disabled.
•Highlight “Scan for upgrade” menu with “
” or “
” keys and pres OK to commence upgrade.
•After the search progress is completed, the message “ Completed searching for upgrade. No new software was found” appears on the screen if no new software is found.
•Do not forget to re enable the automatic OAD function after you have made your recording by repeating the above instructions but this time selecting ENABLE.