Press OK to cancel. Select Yes by pressing “ 
” or “
” button and press OK to delete all of
the channels.
First Time Installation
The user can use this item to load default settings, which were loaded to the receiver at the factory.
To install factory settings, highlight “First Time Installation” menu item and press OK button, then you will be asked whether or not to delete the settings. Selecting “Yes” by pressing OK button while the “Yes” is highlighted will delete the existing channel table.
Then you will be asked to confirm for deleting all channels and settings:
By selecting Yes and pressing the OK button, the existing channel table will be deleted.
After factory settings are loaded, “First Time Installation” menu will be displayed.
The menu which is displayed for language selection appears on the screen at first. By using “
” or “
” buttons, select the desired language option, and press OK button to activate.
After then, “First time installation” OSD will appear on the screen. By pressing “
” or “
” buttons, select the Country you want to set and press OK button (* only for EU countries).
-Next, active antenna mode selection OSD will appear on the screen.Use “
” or “
” to set and press OK to continue.See the section, “Initial Settings” for more information.
After active antenna mode option is selected, a message asking for automatic search appears on the screen:
Press the OK button to start installation. After search is completed for digital channels, a message asking whether to search for analogue channels appears on the screen:
Press the OK button to search for analogue channels. The following menu appears on the screen for analogue channel search:
Select your Country, Language and TXT Language by using “
” or “
” and “
” or “
” buttons. Press OK or RED button to continue. To cancel, press BLUE button. The following menu will be displayed during the automatic tuning:
After APS is finalized, the programme table will appear on the screen. In the programme table you will see the programme numbers and names assigned to the programmes.
If you do not accept the locations and/or the programme names, you can change them via the program table.
Media Browser
•To display Media Browser window, press either “MENU” button on the remote control and then select Media Browser by pressing “
” or “
” button. Press OK button to continue. Media Browser menu contents (depending on the contents of your USB drive) will be displayed.