Cobalt Networks 9032 owner manual Information Submenu

Page 15

Load Settings

In this parameter, move the toggle switch up to load the saved settings and make them active.

Restore Factory Settings

In this parameter, move the toggle switch up to make the factory default settings active, and make the stored settings equal to the factory settings.

Information Submenu

Menu Structure

Parameter Type

Info

+POW

Positive Watts Consumed

 

-POW

Negative Watts Consumed

 

SWR#

Software Release Number

 

SWB#

Software Build Number

Positive Watts Consumed

A read only indication of power consumed by the card from the frames +12V rail.

Negative Watts Consumed

A read only indication of power consumed by the card from the frames +-7.5V rail.

Software Release Number

A read only indication of the software release number. A higher number is newer release of software.

Software Build Number

A read only indication of the software build number. Software build number is an internal indicator used by Cobalt engineers to differentiate different software builds.

Factory Default Settings

The factory default settings are as follows

1)The proc module is enabled, but all parameters are set to unity.

2)The Frame Sync is disabled, reference 1 or 2 must be chosen to enable the frame sync.

9032 Owner’s Manual (V 2.0)

Page 15 of 24

Image 15
Contents 9032 Trademarks CopyrightImportant Regulatory and Safety Notices Symbol MeaningsImportant Safety Instructions Environmental Information Contents Overview IntroductionThis Chapter Word of ThanksFunctional Block Diagram Supported Audio and Video FormatsDocumentation Terms Installation and Setup Static DischargeUnpacking Rear Module Installation Rear Module Installation OptionalBNC Designations for the Card Rear Module available for Rear Module Available forSoftware Version Board InstallationCard Control and Status Menu StructureVideo Submenu Frame Sync Submenu Display Submenu Preset SubmenuInformation Submenu Remote Control Using the Menus and Menu DescriptionsDashBoard Control System Software Controls PresetsVideo Signal Frame SyncVideo Proc Technical Specifications Reference Video InputOther Troubleshooting Checklist Service InformationCase of Problems Warranty and Repair PolicyOptional Equipment Ordering InformationRelated Products Standard EquipmentContact Us Contact Cobalt Digital IncVisit us at the Cobalt Digital Inc. website