Zenith XBV342 Connections Basic TV Connections, RF coaxial connection, Audio/Video connection

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on the capabilities of your existing equipment.

RF coaxial connection

Connect the RF.OUT jack on the DVD+VCR to the antenna in jack on the TV using the 75-ohm Coaxial Cable supplied (R).

ote

If you use this connection, tune the TV to the DVD+VCR’s RF output channel (CH 3 or 4).

How to set up the DVD+VCR’s RF output channel

1.While the DVD+VCR is turned off, press and hold CH (v/V) on the front panel for about five seconds.

The unit will turn itself on and “RF 03” or “RF 04” appears in the display window.

2.Use CH (v/V) on the front panel or CH/TRK (v/V) on the remote control to change the RF output channel (CH 03 or CH 04).

3.Turn the DVD+VCR off and then on.

4.Select TV CH to 3 or 4 depending on the RF output channel you had selected.

Now you can watch the DVD+VCR playback on TV Channel 3 or 4.

Audio/Video connection

1	Connect the DVD/VCR VIDEO OUT jack on the
	DVD+VCR to the video in jack on the TV using the

video cable supplied (V).

2 Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD+VCR to the audio left/right in jacks on the TV (A1) using the supplied audio cables.

ote

If you use this connection, set the TV’s source selector to VIDEO.

TV Connections Panel

ANTENNA	AUDIO INPUT		VIDEO
INPUT			INPUT
	L	R

R A1 V

DVD+VCR Connections Panel

12