Zenith XBR411 warranty Connections Connecting to a TV

Connections (Continued)

Connecting to a TV

Make one of the following connections, depending on the capabilities of your existing equipment.

RF coaxial connection

Connect the RF.OUT jack on the VCR/DVD Recorder to the antenna in jack on the TV using the 75-ohm Coaxial Cable supplied (R).

Note :

If you use this connection, tune the TV to the VCR/DVD Recorder’s RF output channel (CH 3 or 4).

How to set the VCR/DVD Recorder’s RF output channel

When the VCR/DVD Recorder is turned off, press and hold CH (v/V) on the front panel for about five seconds to change the RF output channel (CH 03 or CH 04). “RF-03” or “RF-04” appears in the display window.

Audio/Video connection

1Recorder to the video in jack on the TV using the video cable (V).Connect the VIDEO OUT jack on the VCR/DVD

Connect the Left and Right AUDIO OUT jacks						from
2 the VCR/DVD Recorder to the audio left/right in
jacks from the TV using the audio cables (A).
Rear of TV
ANTENNA	S-VIDEO	VIDEO	AUDIO INPUT	COMPONENT/PROGRESSIVE VIDEO INPUT
INPUT	INPUT	INPUT
			L R	Pr	Pb	Y

R S V A C

Rear of VCR/DVD Recorder

S-Video connection

1Recorder to the S-Video in jack on the TV using the S-Video cable (S).Connect the S-VIDEO OUT jack on the VCR/DVD

2 Connect the Left and Right AUDIO OUT jacks from the VCR/DVD Recorder to the audio left/right in jacks on the TV using the audio cables (A).

Component Video (Color Stream®) connection

1VIDEO OUT jacks on the VCR/DVD Recorder to

the corresponding in jacks on the TV using an Y Pb Pr cable (C).Connect the COMPONENT/PROGRESSIVE SCAN

2 Connect the Left and Right AUDIO OUT jacks from the VCR/DVD Recorder to the audio left/right in jacks on the TV using the audio cables (A).

Progressive Scan (ColorStream® pro) connection

•If your television is a high-definition or “digital ready” television, you may take advantage of the VCR/DVD Recorder’s progressive scan output for the highest video resolution possible.

•If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the VCR/DVD Recorder.

1VIDEO OUT jacks on the VCR/DVD Recorder to

the corresponding in jacks on the TV using an optional Y Pb Pr cable (C).Connect the COMPONENT/PROGRESSIVE SCAN

2 Connect the Left and Right AUDIO OUT jacks from the VCR/DVD Recorder to the audio left/right in jacks on the TV using the supplied audio cables

(A).

Notes :

•Set Progressive Scan option to “ON” in the General menu, see page 20.

•Progressive Scan does not work with the RF, Audio/Video or S-Video connections.

16