Radio Shack 6-IN-ONE TOUCHSCREEN REMOTE owner manual Direct code set up, Been entered

6-IN-ONE

QUICK START GUIDE (CONTINUED)

SETTING UP THE REMOTE

The remote is preprogrammed at the factory to operate an RCA TV,VCR, DVD and satellite receiv- er, and Pioneer CD and audio devices. To control devices other than the default brands, perform the following steps and repeat them as needed for each device to be programmed; otherwise skip this section.

Direct code set up

TO SET UP THE REMOTE FOR YOUR TELEVISION:

1.Find your device code in the Manufacturer’s code section (page 46 – 60).

Codes are listed by device type and brand name. The most popular code for each brand is listed first.

2.Make sure your television is switched on.

3.Press and release TV.

4.Hold down P for at least 3 seconds. The bottom of the IR Indicator blinks twice, and a circle appears around P.

5.Enter your four-digit code using the number keys. The bottom of the IR Indicator blinks once after each of the first three digits are entered. After the fourth digit, it blinks twice to confirm that a valid four-digit code has

been entered.

6.Aim your remote at your television and press POWER. If your television switches off, your remote is ready to control your television.

•IF YOUR DEVICE DOES NOT RESPOND, FOLLOW STEPS 1 THROUGH 6 WITH EACH CODE LISTED FOR YOUR BRAND. IF NONE OF THE CODES LISTED FOR YOUR BRAND OPERATE YOUR DEVICE, SEE “SEARCH METHOD” ON PAGE 12 FOR OTHER OPTIONS.

•SOME CODES ARE QUITE SIMILAR. IF YOUR DEVICE DOES NOT RESPOND OR IS NOT FUNCTIONING PROPERLY WITH ONE OF THE CODES, TRY ANOTHER CODE LISTED UNDER YOUR BRAND.

•IF THE ORIGINAL REMOTE CONTROL FROM YOUR VCR DID NOT HAVE A POWER KEY, PRESS PLAY INSTEAD OF POWER DURING STEP 6.

•TO SET UP YOUR OTHER DEVICES, FOLLOW THE SAME INSTRUCTIONS ABOVE, BEING SURE TO PRESS THE APPROPRIATE DEVICE KEY DURING STEP 3.

•REMEMBER TO PRESS THE CORRECT DEVICE KEY BEFORE OPERATING YOUR DEVICE. ONLY ONE DEVICE (CD, AMPLIFIER, CABLE, ETC.) CAN BE

10 Quick Start Guide