Radio Shack 4-in-One Smart Light-Up Remote Control If YOU have Problems, Manual Code Search

15-1993.fm Page 14 Wednesday, October 20, 1999 12:03 PM

IF YOU HAVE PROBLEMS

MANUAL CODE SEARCH

If the 4-in-One Smart Light-Up Remote Control does not operate your remote-controlled devic- es when you first set it up, you might have to manually find the correct codes for your devic- es. You can try all the codes listed in “Manu- facturer Codes” on Page 17 for your brand device, or you can follow these steps to search the remote control's entire library.

1.Manually turn on the device you want to set up.

2.Press the corresponding device key (TV,

VCR, CBL, or AUX).

3.Hold down P until the red light blinks twice, then press 9 9 1. The red light blinks twice again.

4.Aim the remote control at the device you want to operate.

5.Repeatedly press POWER then the device key (TV, VCR, CBL, or AUX) until the device turns off.

6.When the device turns off, press P within 10 seconds to save the code. The red light blinks twice.

Note: If you do not press P within 10 sec- onds, the remote control does not save the code.

•Because the 4-in-One's library has so many codes, this can take several min- utes.

•If your device turns off during the search, but does not operate after you lock in the code, begin the search again, pausing longer between key presses.

14