Williams Sound model wir 240/250 Setting up the RX240 Receiver, Install the Receiver Batteries

Page 10

Setting up the RX240 Receiver

Step 1: Install the Receiver Batteries

Insert the rechargeable battery into the bottom of the RX240 Receiver (see page 11). Place the receiver into the charger cradle built into the top of the TX240 Transmitter and let charge overnight. The spare battery can be plugged into the charging port located on either side of the transmitter. By keeping the spare battery charged, you can easily swap batteries when the one in use runs out and always have a fresh battery ready. A fully charged battery will operate the receiver for approximately 7 hours, depending on the volume setting. The battery should be changed when you notice the sound getting weak and noisy. The batteries may be left charging when not in use.

Step 2: Using the WIR RX240 Receiver

The RX240 will automatically configure itself for stereo or mono (2.3 or 2.8 MHz) operation depending on the setup chosen for the TX240 Transmitter.

To use the system, first check to make sure your TV or audio source is turned ON. Make sure the receiver battery is fully charged. The RX240 Receiver has an automatic on/off function. When you put the receiver on, it turns on. When you take the receiver off, it turns off. Rotate the volume control to adjust the volume to a comfortable level.

IMPORTANT: A dual detector infrared “eye” is located in the front of the receiver. Do not cover it up or you will lose reception. Make sure the “TV TALKER” lettering is facing away from you when you put the receiver on.

Return the receiver to the charger when it is not in use.

Additional Receiver Adjustments

Balance Control: Use a small screwdriver to adjust the loudness balance between the left and right earphones. See page 11.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Manual and User Guide Contents System Overview System ComponentsSafety Information To protect your hearing and the hearing of othersPacemaker Safety Recycling InstructionsSetting up the TX240 Transmitter ❺ TV Microphone Connect the Transmitter Power SupplyTX240 Transmitter Rear View Connect the Transmitter to the Audio SourceStep Select Stereo or Mono OperationMHz Mono Operation Using the WIR RX240 Receiver Setting up the RX240 ReceiverInstall the Receiver Batteries Additional Receiver AdjustmentsRX240 Receiver Using the WIR RX250 Receiver Setting up the RX250 Neckloop ReceiverTo use the Receiver RX250 Receiver Case of Difficulty If the system does not seem to be functioningLimited Warranty Page WIR 240, WIR System SpecificationsWIR TX240 Transmitter WIR RX240 Receiver WIR RX250 ReceiverPage Williams Sound MAN 147E
Top Page Image Contents