Recommended Receivers | Winegard SK-7002 specification

Congratulations!

You have selected the Winegard® TRAV’LER Automatic Multi-Satellite TV Antenna. The TRAV’LER antenna will deliver the ability to view both SHAW DIRECT satellites at the same time with unmatched signal strength, the lowest travel height on the market, maximum HD capabilities and easy to use func- tionality – just like you get at home. This manual provides important information on the installation and operation of your TRAV’LER Interface Box. Please take time to read the manual in it’s entirety before installing or operating your antenna.

Icons appearing in the manual are used for important information and helpful tips. Alert indicates important information regarding

product use, product specifications or procedures.

Important tip offers helpful suggestions or refers you to a related topic in the manual.

Recommended Receivers:

The Winegard® TRAV’LER Automatic Multi-Satellite TV Antenna will work with any SHAW DIRECT™ receiver currently in production. Consult your receiver manual or www.winegard.com if you have any questions about whether your receiver is compatible. However, we recommend:

SHAW DIRECT - DSR505 (HD capable)

DSR207 (SD only)

DVR530 (HD capable DVR)

Each receiver will require at least one coax cable. Refer to receiver manual for wiring details.

For information regarding Satellite coverage in North America, call Shaw Direct at 1-888-554-7827.

Before you begin, please make sure you have received all necessary parts to properly install and oper- ate your TRAV’LER antenna.

-Installation and Operation Manuals

-Mount Base with 30’ Cable - Power/Control Cable

-TRAV’LER Interface Box

-Reflector, LNBF & Feed Arm (Packaged separately as the SKA-722)

-TRAV’LER Power supply with 24’ AC power cord

-Gray Coax Cable 30’

-Black Coax Cable 30’

-Mounting Hardware bag

-Cable Entry Hardware bag

Selecting a Location for the TRAV’LER Antenna

Before removing the TRAV’LER antenna from its box, check with your RV Dealer or manufacturer. Your RV may be pre-wired or have a reinforced area for this system. DO NOT install in a location where a gap of 3/16” or more exists, as it may damage the roof. See diagram at top of page 3.

When installing the TRAV’LER on a rubber roof, Winegard recommends using the SKA-004 Roller Plate. If not using this plate, make sure that the roller does not come in contact with any rib supports or bubbles in the roof when in operation. Failure to do so, may result in damage to the roof.

INSTALLATION