Winegard LP-1000 operation manual Operational Safety

Page 5

Fig 1.1

Rotate Base

40.00”

PCB

Main Control

Assembly

Electronics

Sub-base

28.625”

33.500”

EL Motor

LNBF

28.625”

Azimuth

Motor

Pill Box

GPS

Cable Clamp

33.250”

Knee Reflector

Reflector

Base

Back Reflector

Foot

2.2 Operational Safety:

RoadTrip LP is capable of advanced on-road television satellite tracking. Satellite tracking systems are designed for reception of television programming while the vehicle is in motion and should only be used or operated by vehicle passengers while the vehicle is in motion.

Antenna systems and associated equipment should never be oper- ated by the vehicle driver while vehicle is in motion.

Active television and video monitors should never be installed in view of the vehicle driver.

Failure of the vehicle driver to pay complete attention to the op- eration of the vehicle could cause an accident that might result in serious injury or death.

5

Image 5
Contents Satellite System Trademarks CongratulationsRoadTrip LP Model Number Appendix B Appendix aParts Provided with RoadTrip LP Installation SafetySystem Overview Operational Safety Tools and Material Required for Installation Installation OverviewUnpack and Inspect the RoadTrip LP Select a Location to Mount the AntennaOption a Option B Mounting the Antenna Hardware Kit Hardware Kit ContentsSat. Rcvr Mount Option Adjusting the Antenna Switch SettingsRoute and connect the coax and wires ON/OFF Operation Initial Satellite Receiver SetupTracking with the RoadTrip LP Satellite Signal InterruptionDish Network Directv Using your Dish Network Point Dish/Signal Screen Appendix B Setup and Operation of Satellite ReceiversFig B.1.2 Using your Dish Network Receiver for Multidish OperationUsing the Directv Dish Pointing Screen Set up your Directv Receiver DishUsing your DirecTV Receiver for MultiDish Operation Directv To activate your Directv receiver, callTighten coax connectors with wrench, Section Appendix C. Maintenance and TroubleshootingSymptom Warranty Procedure Appendix D. Specifications and WarrantySpecifications