Installation
The default switch settings (all switches in the UP position) will work for most installations.
These are the steps required to configure the Perle Fast Fiber to Fiber media converter:
1.Set the DIP switch settings (optional).
2.Install and connect the fiber cable to port MM1.
3.Install and connect the fiber cable to port MM2/SM2.
4.Power up the media converter.
DIP Switches
The DIP switches are accessible through the opening in the side of the enclosure
Note: All switch changes take effect immediately and will result in a link reset on both fiber ports.
Fast Fiber to Fiber Media Converter – Installation Guide 3