Perle Systems S-100MM-XXXXX Operation, Status LED, PWR Power/Test, LK1 MM1 Fiber Link 1 Activity

Page 8

Operation

Status LED

The Perle Fast Fiber to Fiber Media converters have three single colored status LEDs located on the front panel of the unit.

PWR - Power/Test

On: Power is on and in normal operation.

Blinking slowly: the unit is in loopback mode.

Blinking quickly: the unit has a hardware error.

LK1 – MM1 (Fiber Link 1) Activity

On: Fiber link present.

Blinking quickly: Fiber link present and receiving data.

OFF: No fiber link present.

LK2 – MM2/SM2 (Fiber Link 2) Activity

On: Fiber link present.

Blinking quickly: Fiber link present and receiving data.

OFF: No fiber link present.

Fast Fiber to Fiber Media Converter – Installation Guide 8

Image 8
Contents 100MM-XXXXX Overview Fiber port 2 MM2/SM2Installation DIP SwitchesDIP Switch Settings Link Mode SwitchFar End Fault Switch Switch Position ModeIllustration of the FEF feature Sequence of EventsRemote Loopback Fiber 1 Switch Remote Loopback Fiber 2 SwitchInstalling the Duplex Fiber Cable Installing the Simplex Fiber CablePWR Power/Test OperationStatus LED LK1 MM1 Fiber Link 1 ActivityTroubleshooting GeneralNo connectivity MethodTechnical Specifications Fiber Optic Specifications432,138 hours Fiber port 1 MM1Fiber Cabling Requirements EN 55022 Class B EN 55024 Class a Laser Safety IEC Compliance InformationCopyright Warranty / RegistrationContacting Technical Support