Palsonic VCR9600 owner manual Installation, Equipment Connection, TV Antenna, Power Supply Cable

Page 8

INSTALLATION

Equipment Connection

TV Antenna

To watch a picture from the VCR using this connection, it is necessary to set one of the TV channels as the "Video channel". See Preparations in Video Channel Setting (on Page 6).

1.Connect the antenna (or CATV) connector to the ANT. IN socket.

2.Connect the accessory coaxial cable between the RF OUT socket and the TV.

Connection of VCR and TV Using Audio/Video Connector

In this case use the A/V mode specified on your TV, instead of UHF channel 32 or another unoccupied channel.

Power Supply Cable

Connect to a wall AC outlet.

E-5

Image 8

Contents VCR-9600 How to Use This Manual Remote control unit Remote Control Unit Front PanelRear Panel Multi-displayMaintain Good Ventilation Contents Introduction Installation Connection of VCR and TV Using Audio/Video ConnectorPower Supply Cable Equipment ConnectionPreparations Initial Setting Up Changing the Language after the Initial SettingsChanging the Time after the Initial Setting To Execute AMS again after the Initial SettingOn Screen Display OSD Using the Menu ScreenMenu Screen/Mode Screen Channel Presetting Manual TuningAMS Operation Automatic Channel ChangingTuning with the V CH V Buttons Tuning with the Number Buttons Remote Control OnlyChannel Selection Selecting AUX PositionAuto Head Cleaner PlaybackBasic Operation Digital Tracking ControlSpecial Effect Playback SearchStill Frame Frame AdvanceBlueback Function Minute SkipZero Return Recording One-touch Timer Recording OTR Counter FunctionCounter Display Changing OTR DurationBefore programming Programmable Timer RecordingProgramming procedure When two programmes overlap Hints on ProgrammingSymptom Cause Remedy OthersSpecifications General Section Palsonic Customer Service Telephone