Palsonic 76WSHD owner manual Vcr, Setting of colour and sound system, Use OSD button

7.4.2 FINE TUNE

1)	Press the number buttons (4) or						(4)
	CH	button (3) to select the		(3)
					(1)
	channel you want to fine-tune.
2)				(2)		(2)
	Enter into the PRESET menu,
					(3)
	press CH		button (3) to select

Fine tune, then press and hold the VOL or VOL button (2) to begin fine-tune until the optimum picture and sound is achieved.

!Note: if some channel’s colour or sound is abnormal, it may be that the setting of the colour or the sound system is wrong, please do adjustment according to "8.6 The setting of colour and sound system" to set the proper colour and sound system.

7.5 VCR

When receiving VCR programs, there may occur jump of the picture or bend of upper picture. You can solve this problem by activating VCR function. Please do the following steps:

Enter into the PRESET menu, press CHor CHbutton to select VCR item, and press VOL or VOL button to set VCR (ON).

If you do not meet this problem, or the signal source is not from VCR, please shut off this function.

7.6 The setting of colour and sound system

7.6.1 Use OSD button

(1)	PAL 6.5MHz
	100Hz MOVING

Press OSD button (1), the screen will display position number, colour and sound system. scan mode etc. Check whether the colour and sound system is correct.