Connection

CONNECTING THE DVD TO A TV USING THE AUDIO/VIDEO OUTPUT JACKS

CONNECTING THE DVD TO A TV USING THE S-VIDEO OUTPUT JACK

To	To
Audio In	Video In

From	Audio Cable (Included)
From	Video Cable (Included)
Audio	From
Out	Video Out

Audio In

		Audio Cable (Included)
From	S-Video Cable (Not Included)
Audio		From
Out		S-Video Out

To S-Video In

NOTES FOR CONNECTING TO A TV:	and both units are unplugged before making any connections.
• If your TV has an S-Video input, connect the DVD player with	• If your TV only has one audio input, the use of a “Y” connector
the S-Video cable for best results.	may be necessary. Visit your local electronics supply store.
• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.	• Connect the DVD player to your TV directly. If you connect the
• When connecting the DVD, refer to the owner’s manual of the	DVD player through a VCR, the playback picture will be
TV, as well as this manual.	distorted because DVD video discs are copy protected.
• When connecting the DVD to the TV, make sure the power is off

CONNECTING THE DVD TO A HOME THEATRE SYSTEM

From

Digital Out

From	Coaxial Cable (Not Included)			To Digital
Video Out	Coaxial Cable (Not Included)			To Digital
	Video Cable (Included)			Audio Input
		To Video		9
		Input
	1	2	3	4	5

Place the subwoofer, front, rear and center speakers in locations as shown/described here. After correctly positioning the speakers, perform the Tone Test on the AV Amplifier and adjust the volume controls until the desired sound is achieved. For best results, sit in the viewing position and have someone adjust the volumes for you; this will enable you to set the optimal levels.

NOTE:The rear speakers can also be located on the side wall facing the viewing position and each other. Make sure the viewing position is located between the 2 speakers in this case. Experiment to find optimal position.

1.	Front Left Speaker		best listening position is obtained
2.	Television		by positioning the chair, sofa, etc.
3.	Center Speaker–can be located		in the middle of all the speakers.
	on top or below the Television.	7.	Rear Left Speaker
4.	Sub-woofer–can be located	8.	Rear Right Speaker
	anywhere in the room.	9.	AV Amplifier w/Dolby Digital
5.	Front Right Speaker		Decoder/DTS Decoder
6.	Viewing/Listening Position–The

NOTES FOR CONNECTING TO A TV:

•If your TV has an S-Video input, connect the DVD player with S-Video cable for best results.

•Set the TV’s TV/VIDEO button or switch to the VIDEO setting.

•When connecting the DVD, refer to the owner’s manual for the TV and the audio system, as well as this manual.

•When connecting, make sure the power is off and all units are unplugged before making any connections.

•Connect the DVD player to your TV directly. If you connect the DVD player through a VCR, the playback picture will be distorted because DVD video discs are copy protected.

•If using a TV with a blue screen option, turn the option off, on the TV for best results.

•If you place the DVD player near a tuner, the radio broadcast sound might be distorted. In this case, move the DVD player away from the tuner.