Marantz HD-DAC1 Connect and playback from a digital device COAX/OPT1/OPT2, Coax OPT1 OPT2

Contents Connections Playback Settings Tips Appendix

Connect and playback from a digital device (COAX/OPT1/OPT2)

1Press COAX, OPT1 or OPT2 to switch the input source to “COAX”, “OPT1” or “OPT2”.

The digital audio signal that is being input is shown as follows in the display.

“COAX	or	“OPT1	or	“OPT2
xxxxk”		xxxxk”		xxxxk”

(xxxx is the sampling frequency.)

0If the sampling frequency cannot be detected, “Unlocked” will be displayed.

0“Unsupported” is displayed when audio signals that are not supported by this unit are input.

oFiles that can be played back

See “D/A converter” (v p. 62).

NOTE

0Do not input non-PCM signals, such as Dolby Digital, and DTS. This causes noise and could damage the speakers.

0If the sampling frequency switches, such as from A mode to B mode in a CS broadcast, muting may operate for 1 – 2 seconds, cutting the sound.

Front panel Display Rear panel 37 Remote Index