** | ** |
|
|
**
**
5. Search
You can complete the setting and start searching.
1.Select Search and press the OK 
button to start Channel Search.
2.Wait while the recorder searches for the channels, this may take a few minutes.
3.During operating search, the cursor is located at Stop.
Therefore, if you press the OK 
button during searching, the operation is stopped and only the channels found so far will be displayed.
4.If the search operation is successfully completed, and no
channels are found, press the OK 
button and try to reset the search operation again if necessary.
5.You can delete unnecessary channels from the searched channels. Select your desired channels to delete and
press the OK 
button. Then select Delete and press
the OK 
button. To delete all channels, select Select All to select all channels, select Delete, and press the OK 
button.
6.When completing channel search and deleting unnecessary channels, select Save, and press the OK 
button to save the changes.
**
**
**
**
**
GB 61
**
**
**
**
**