KTI Networks KC-1300 operation manual Removal of System Power Chassis

Page 18

Removal of System Power Chassis

The system power chassis is pre-installed in the system unit when sys- tem unit is shipped from factory. The chassis is designed for easy un- installation from system unit in case of any inspection purpose. How- ever, note that this removal only can be performed by a well-trained technical person.

For safety reason before removing the power chassis, make sure:

•The power switch is turned off.

•The power cord is disconnected from the power chassis.

To remove the chassis, unscrew two chassis screws until they are re- leased from system chassis, hold the handle and pull the chassis out from the system chassis smoothly. See the following example figure:

-18-

Image 18

Contents Modular Media Converter Center System KC-1300United States InternationalTrademarks Network Management Table of Contents IntroductionInstallation Console and Telnet OperationPage Introduction Features Technical Specifications System ModelAC Power Chassis Module Specifications System interface Update Firmware Unpacking System UnitsPage Management Module LED Indicators Color States Interpretation Console Port UTP Port Power Chassis Modules AC Power Chassis Specifications KC1300-ACDC Power Chassis Specifications KC1300-DC Removal of System Power Chassis Insertion of System Power Chassis Media Converter Slots Page Rack Mounting Management Functions Management Interface RS-232 / ProtocolProtocols Supported Protocols Name ReferenceSetup for Out-of-band Console Management Factory default settings of the Console port Setup for In-band Management Functions supported Management Objects Modify MonitorPower-on Self-test Cold StartLogin Prompt Direct Console ManagementTelnet Management When login successfully, a Setup menu is shown as follows IP Menu Set IP AddressView IP Status Contact Snmp MenuLocation CommunityView System Status View Converter Slots Status Slot status definitions are Restore Default Values Change user name and password Security ManagerDisplay current user name Update Firmware Following information are required for Tftp operationsSpecify Tftp server IP address Reboot SystemConfirm to update system flash memory Confirm to start downloadingSnmp Management Configuring Snmp Settings via Console Operation Snmp Private MIB Private MIB Objects Get RemarkSnmp Traps TrapName Event ofTrapGeneratedTrapName VarBind Start Browser Software and Making Connection Web BrowserSet IP Address for the System Unit Login to the System Unit LoginPage Converter Status Information includes System Status Administrator Menu Basic Page Snmp Entries System options Access right Snmp Entries Community StringsSnmp Entries Trap Managers Console Port Information Security Manager Image Refresh Time Update Firmware Reboot System Slot Icon Operations