FUNAI MSD126 Location and handling, Avoid the hazards of Electrical Shock and Fire, Maintenance

Page 4

Precautions

Location and handling

Do not stand this unit up vertically. Install this unit in a hori- zontal and stable position. Do not place anything directly on top of this unit. Do not place this unit directly on top of the TV.

Depending on the TV, noise or disturbance of the picture and/or sound may be generated if this unit is placed too close to your TV. In this case, please ensure enough space between your TV and this unit.

Do not cover or place this unit in enclosed spaces to prevent excessive temperature build up.

Do not place this unit in direct sunlight, or near heat sources.

Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction.

Keep this unit away from strong magnetic objects.

Do not place any object containing water or other liquids on this unit. In the event that liquid should enter the cabinet, unplug this unit and contact the retailer or an Authorized Service Center immediately.

Do not remove this unit cabinet. Touching parts inside the cabinet could result in electric shock and/or damage to this unit. For service and adjustment inside the cabinet, call a qualified dealer or an Authorized Service Center.

Be sure to remove disc and unplug the AC power cord from the output before carrying this unit.

Avoid the hazards of Electrical Shock and Fire

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from AC wall outlet. Grasp it by the plug.

If, by accident, water is spilled on this unit, unplug the power cord immediately and take the unit to our Authorized Service Center for servicing.

Warning of Dew Formation

Moisture may form inside this unit under the following conditions:

Immediately after a heater is turned on.

In a steamy or humid room.

When this unit is suddenly moved from a cold to warm environment.

If moisture forms inside this unit, it may not operate properly or damage the disc. In such case, turn on the power and wait for more than 2 hours for the moisture to evaporate.

About Copyright

Unauthorized copying, broadcasting, public performance and lending of discs are prohibited.

This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disas- sembly is prohibited.

Symbols Used in This Manual

The following symbols appear in some headings in this manual.

:Description refers to playback of DVD-Video discs.

:Description refers to playback of Audio CDs.

Maintenance

SERVICING

Please refer to relevant topics on the “Troubleshooting Guide” on page 17 before returning the unit.

If this unit becomes inoperative, do not try to correct the problem by yourself. There are no user-serviceable parts inside. Turn off, unplug the power plug, and please call our help line mentioned on the front page to locate an Authorized Service Center.

CLEANING THE CABINET

Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasive.

CLEANING DISCS

When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center to out. Do not wipe in a circular motion.

Do not use solvents such as benzine, thinner, commercial- ly available cleaners, detergent, abrasive cleaning agents or antistatic spray intended for analog records.

CLEANING THE DISC LENS

If this unit still does not perform properly although you refer to the relevant sections and to “Troubleshooting Guide” in this Owner’s Manual, the laser optical pickup unit may be dirty. Consult your dealer or an Authorized Service Center for inspection and cleaning of the laser optical pickup unit.

DISC HANDLING

When you handle a disc hold it by its edge and try not to touch the surface of the disc.

Always store a disc in its protective case when it is not used.

Notice for Progressive Scan Outputs

Consumers should note that not all high definition television sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of picture problems with 525 progressive scan output, it is recom- mended that the user switch the connection to the ‘standard definition’ output. If there are questions regarding your TV set compatibility with this 525p DVD player, please contact our customer service center.

Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

-4-

EN

Image 4
Contents Setup Precautions Español Information Functions Precautions Laser SafetyRADIO-TV Interference Make your contribution to the environmentImportant Safeguards PrecautionsSymbols Used in This Manual MaintenanceLocation and handling Avoid the hazards of Electrical Shock and FireAbout the Media Playable MediaUnplayable Media On the following disc, the sound MAY not be heardSetup ConnectionsHint Connection to a TVSetup Front Panel Indicator and Rear TerminalsConnection to an Audio System Rear TerminalsRemote Control About the Remote ControlInstalling the Batteries for the Remote Control Playback FunctionsFunctions Using Search Mode Using Skip H , GOn-Screen Display Search FunctionUsing Time Search Marker Setup To set a markerTo return to the marker later To exit the marker displayRepeat / Random / Programmed Playback Repeat Playback Random PlaybackProgrammed Playback Repeat A-B PlaybackSpecial Settings To set subtitle ON/OFFDVD Setup DVD Quick Setup MenuLanguage Setting Custom MenuAudio Setting Display SettingAudio menu To Change the Password for Parental Controls Parental SettingOThERS Setting Parental LevelsTroubleshooting Guide Reset to the Default Setting Except for Parental SettingInformation InformationSpecifications Language Code ListLimited Warranty LanguageEspañol EspañolConexiones ReproducciónInstalling the Batteries for the Remote Control Quick Use GuideConnections To Change the On-Screen Language