FUNAI LC225SL9 owner manual Do not handle the power cord with wet hands, Location and Handling

Page 3

This apparatus should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided. Make sure to leave a space of 2.8 inches (7cm) or more around this apparatus.

Disconnect the mains plug to shut off when find trouble or not in use. The mains plug shall remain readily operable.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

WARNING: Batteries (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

LAMP IN LCD CONTAINS MERCURY, DISPOSE ACCORDING TO LOCAL, STATE OR FEDERAL LAW.

WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the instructions.

TO AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE

Do not handle the power cord with wet hands.

Do not remove this unit cabinet. Touching parts inside the cabinet could result in electric shock and/or damage to this unit. For service and adjustment inside the cabinet, call a qualified dealer or an authorized service center.

Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

Do not put your fingers or objects into the unit.

LOCATION AND HANDLING

The openings should not be blocked by placing the unit on a bed, sofa, carpet, rug, or other similar surface.

Do not install the unit near or over a radiator or heat register.

Do not install the unit in direct sunlight, near strong magnetic fields, or in a place subject to dust or strong vibration.

Avoid a place with drastic temperature changes.

Install the unit in a horizontal and stable position. Do not place anything directly on top or bottom of the unit. Depending on your external devices, noise or disturbance of the picture and/or sound may be generated if the unit is placed too close to them. In this case, please ensure enough space between the external devices and the unit.

Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction.

NOTE ABOUT RECYCLING

• This unit’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

INTRODUCTION PREPARATION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING

INFORMATION

3

EN

Image 3
Contents LC225SL9 RADIO-TV Interference PrecautionsIntroduction FCC WarningDo not handle the power cord with wet hands Avoid a place with drastic temperature changesLocation and Handling 5Trademark Information 5Supplied Accessories5Symbols Used in this Manual 5Attaching the StandFeatures ContentsDTV/TV/CATV 5Buttons on the Remote Control 5Installing the BatteriesBattery Precautions 5Rear Panel 5Control PanelConnection to Cable Box or Satellite Box Preparation5Basic Connection Antenna Connection5External Device Connection Hdmi ConnectionHDMI-DVI Connection Video Connection Component Video ConnectionRCA audio cable RCA video cable Camcorder Video game Digital audio coaxial cableDolby Digital Following signals can be displayed Format Resolution FrequencyPC Connection Before you begin Initial Setting5Initial Setup 5Main MenuRefer to Language Selection on 5Auto Channel Scan5Language Selection Language5Channel Selection 5Sleep TimerTo Cancel the Sleep Timer Watching TV5Still Mode 5Switching Each Input Mode5Switching Audio Mode Day of Memories 5Screen InformationBroadcasting Information Press InfoDigital mode 5TV Screen Display ModeFor 43 video signal For 169 video signalNormal *B For PC input signalNormal * a Full Dot By Dot Normal *AEnter Optional Setting5Channel List 5Manual RegisterAntenna 5Antenna Confirmation5Picture Adjustment Adjust the sound setting 5Sound AdjustmentYou can adjust treble and bass To restore the sound settings to the defaultCC3 and Text3 Caption Mode5Closed Caption CC1 and Text15DTV Closed Caption DTV CCUse Cursor K/L to select DTV CC, then press Enter Font Size Setting description for each item is shown below5CC Style Font StyleBack Opacity Font ColorFont Opacity Back ColorUse Cursor K/L to select V-chip, then press Enter New Password DpageEnter password ChipTo Set the Sub Ratings Use Cursor K/L to select Mpaa Rating, then press EnterUse Cursor K/L to select TV Rating, then press Enter Category Rating Use Cursor K/L to select New Password, then press EnterChipip Enter password Confirm password TV-14Horizontal Position, Vertical Position 5PC SettingsClock, Phase Auto AdjustmentUse Cursor K/L to select HDMI1 Audio, then press Enter 5HDMI AudioTroubleshooting 5Troubleshooting GuideAll connections once before calling for service May interrupt the remote control signal of this unit Check the batteries of the remote controlRefer to IR Signal Check on My remote control does not work. WhatMaintenance InformationGlossary 5Cable Channel Designations 5General Specifications5Electrical Specification 5Other SpecificationsMemo Limited Warranty LC225SL9 Advertencia DE LA FCC IntroducciónPrecauciones Para consultarlos, si los necesita, en el futuroPara Evitar Peligros DE Descarga Eléctrica O Incendio Colocación Y ManejoNota Acerca DEL Reciclado 5Información sobre Marcas Registradas 5Accesorios Suministrados5Conectar el Soporte 5Símbolos Utilizados en este ManualContenido Características5Botones en el Mando a Distancia 5Instalación de las PilasPrecauciones sobre las Pilas 5Panel Trasero 5Panel de ControlConexión a Caja de Cable o Caja de Satélite Preparación5Conexión Básica Conexión de Antena5Conexión de Dispositivo Externo Conexión HdmiConexión HDMI-DVI Conexión de S-video Conexión de Vídeo en ComponentesAparato de vídeo Conexión de VídeoCable de audio RCA Cable de vídeo RCA Cámara De vídeoFrecuencia vertical Conexión de PCPueden aparecer las siguientes señales Formato ResoluciónAntes de empezar 5Configuración InicialAjuste Inicial 5Menú Principal5Selección de Idioma Presione Setup para visualizar el menú principalPresione Setup para salir 5Exploración Automática de CanalesPara Cancelar el Temporizador de Apagado 5Selección de Canal5Temporizador de Apagado 5Para Cambiar el Modo de Audio Para VER LA Televisión5Modo Fijo 5Para Cambiar Entre Cada Modo de EntradaUn día ía de recuerdos 5Información de PantallaInformación de Emisión Presione InfoModo de entrada analógica/externa 5Modo de Visualización de Pantalla del TelevisorPara señal de vídeo Modo digitalTotal Punto Por Punto Normal *A Para señal de entrada PCPara reactivar un canal removido, utilice Ajuste Opcional5Lista de Canales 5Registro ManualAntena 5Confirmación de la Antena5Ajuste de Imagen Haga el ajuste del sonido 5Ajuste de SonidoAgudo, Grave Puede ajustar el treble y el bajo3 y Texto3 SubtítulosModo de Subtítulos 1 y Texto15Subtítulos en DTV Para seleccionar los subtítulosDTV deseados, y luego presione Enter 5Estilo CC Estilo FuenteTamaño Fuente Opaco Atrás Color FuenteTipo Borde Color FondoClase de Mpaa Clase de TVNuevo Código de Acceso Dpágina Para Ajustar las Subcategorías Clasificación Categoría Nuevo Código de AccesoAjuste Automático 5Ajustes de PCPosición Horizontal, Posición Vertical Reloj, FaseAudio 5Audio HdmiSolución DE Problemas 5Guía de Solución de ProblemasSiguiente tabla antes de llamar al servicio técnico Input Select o utilizando CH K / L 5Preguntas FrecuentesInfrarrojos Con una radio AM InformaciónGlosario Mantenimiento5Otras Especificaciones 5Denominaciones de Canales de Cable5Especificaciones Generales 5Especificación EléctricaMemo Garantía Limitada