FUNAI LC225SL9 5Auto Channel Scan, 5Language Selection, Refer to Language Selection on

INITIAL SETTING

LANGUAGE

You can change the language (English, Spanish, French) displayed on the main menu.

(Refer to “Language Selection” on page 14.)

5Auto Channel Scan

If you switch wires (e.g., between antenna and CATV) or if you move the unit to a different area after the initial setting, or if you restore the DTV channel you deleted, you will need to perform auto channel scan.

Before you begin:

Make sure if the unit is connected to antenna or cables.

1Press [SETUP] to display the main menu.

2Use [Cursor K/L] to select “CHANNEL” , then press [ENTER].

3Use [Cursor K/L] to select “Autoscan”, then press [ENTER].

Note:

•After setting “Auto Channel Scan”, using [CH K/L] on the remote control skips unavailable programs automatically.

•If you connect the cable system directly, contact the CATV installer.

•If you press [POWER] or [SETUP] during auto channel scan, the setting will be canceled.

•Channel settings will be saved even if the power fails.

•If you need the English menus instead of the Spanish or French menus you are having, press [SETUP]. Use [Cursor K/L] to select “IDIOMA” or “LANGUE”, then press [ENTER]. Use [Cursor K/L] to select “English”, then press

[ENTER]. Press [SETUP] to exit the main menu.

•With regard only to the digital channel, even after the scanning is completed if you unplug the AC power cord before turning off the unit by pressing [POWER], the channel setting may be lost.

5Language Selection

You can choose English, Spanish or French as your on-screen language.

1Press [SETUP] to display the main menu.

2Use [Cursor K/L] to select “LANGUAGE”, then press [ENTER].

Channell

Autoscan

Channel List

Manual Register

Antenna

Use [Cursor K/L] to select an appropriate option, then press [ENTER].

3Use [Cursor K/L] to select “English”, “Español” or “Français”, then press [ENTER].

Autoscan

Autoscan will rescan all channels.		Back
This may take a while to complete.		Air
Select the destination of "ANT.IN" jack.		Cable
		Cable
Air		1 hour
Cable	Or
	ANT.IN

Language

Select the language for setup display.	English
Elija el idioma de ajuste.	Español
Sélectionner langue écran config.	Français

• When aerial antenna is connected, select “Air”.
•	When connected to CATV, select “Cable”.
		4 Press [SETUP] to exit.
•	Scanning and memorizing of channels start

automatically.

Now the system is scanning for channels, please wait.

72%

Analog channels		10ch
Digital channels		6ch
SETUP	Exit

•When the scanning and memorizing are completed, the lowest memorized channel will be displayed.

14

EN