Watching TV Channel Selection, Volume Adjustment

WATCHING TV

CHANNEL SELECTION

Select channels by pressing [CH K/L] found on remote control or on the TV’s control panel, or by pressing [the Number buttons] found on the remote control.

POWER	SLEEP	INPUT
		SELECT

1 2 3

NTSC

CH4

18:00

18:30

19:00

19:30

20:00

ATSC

CH4-1No signal No signal

CH4-1 CH4-2 CH4-3

CH4-1 No signal CH4-3

CH4-1 CH4-2 No signal

4 5 6

AUDIO

7 8 9

STILL

- 0

: change automatically

: change manually by pressing [CH /] on your remote control

SETUP	SCREEN
	MODE

	ENTER
BACK		INFO
	CH RETURN
VOL.	MUTE	CH

[CH K/L]

•Use [CH K/L] to change the channel.

•Same operation is also available with [CHANNEL K/L] on the control panel of the main unit.

[the Number buttons]

•Press the channel number with [the Number buttons] to select a channel you want to watch, then press [ENTER].

-When selecting analog channel 12

1 2 ENTER

-When selecting digital channel 12-1

Be sure to press [–]before entering the minor channel number.

1 2 - 1 ENTER

•If the channel broadcasts NTSC and ATSC both and you don't press [–], you will receive the NTSC channel only. The moment you press [–], the lowest memorized digital channel will be dis- played.

•Press [CH RETURN] to return to the previously viewed channel.

NOTE:

•In DTV broadcasting, one channel sometimes broadcasts multiple programs depending on the air time. In this case, the main channel is called major channel and the minor channel is called minor channel.

About minor channel broadcasting:

There may be different programs being broad- cast on minor channels through a single chan- nel from ATSC. You can watch each minor channel program being broadcast by selecting one of the minor channels.

NOTE:

•“No Signal” will appear on the screen after the minor channel broadcast is over.

You will need to change the channel to continue watching another TV program.

VOLUME ADJUSTMENT

This section describes how to adjust the volume. The mute function, which turns the sound off and on, will also be described.

BACK INFO

	CH RETURN
VOL.	MUTE	CH

[VOL. X/Y]

•Use [VOL. X/Y] to adjust the audio volume.

•The same operation is available with [VOLUME X/Y] on the control panel of the main unit.

•The volume bar will be displayed at the bottom of the screen when adjusting the volume.

Volume

•The volume bar display will automatically dis- appear in a few seconds.

[MUTE]

•Press [MUTE] to turn off and on the sound.

Mute

•“Mute” is displayed on the screen for a few sec- onds.

•Press [MUTE] again or [VOL. X/Y] ([VOLUME

X/Y]) to release the Mute status.