FUNAI CIWP4206 A owner manual Depending on the screen, Contents

Page 35

•IGNITION NOISE:

Black spots or horizontal streaks may appear, picture may flutter or drift. Usually caused by interference from automobile ignition systems, neon lamps, electrical drills and other electrical appliances.

•GHOSTS:

Ghosts are caused by the television signal following two paths. One is the direct path and the other is reflected from tall buildings, hills or some other objects. Changing the direction or position of the antenna may improve reception. Ghosting may also be caused by defects in the antenna system such as unshielded leads or connecting several sets to the same antenna without using multiple antenna couplers.

Ghosting occurring when the TV is connected to a cable TV system may indicate a bad cable wire or loose connection. Confirm that the cable wire is properly connected.

•SNOW:

If your receiver is located in the fringe area of a television station where the signal is weak, your picture may be marred by the appearance of small dots. When the signal is extremely weak, it may be necessary to install a special antenna to improve the picture.

Snowing occurring when the TV is connected to a cable TV system may indicate a bad cable wire or loose connection. Confirm that the cable wire is properly connected.

•RADIO FREQUENCY INTERFERENCE:

The interference produces moving ripples or diagonal streaks, and in some cases, causes loss of contrast in the picture.

•PREVENTION OF AN OBSTACLE TO RADIO RECEIVERS:

This TV has been designed pursuant to the FCC class B Rules. This is to prevent a problem to Radio receivers. lf this TV causes a problem to Radio receivers, then take the following steps:

-Keep the monitor away from Radio.

-Adjust Radio antennas in order for the TV not to receive interference.

-The antenna cable of Radio should be kept away from the TV.

-Use a coaxial cable for antenna.

You can check if this TV influences Radio receivers by turning off all other equipment other than the TV.

If you find a problem receiving Radio when using the TV, check the instructions mentioned above.

Vertical stripes appear,

•The plasma display panel is lighting the phosphors by the discharge of

depending on the screen

internal radiation. Depending on the screen contents, in rare cases this

contents.

may cause vertical stripes to appear because of failure to light. Please

 

note that this is not a malfunction.

MISCELLANEOUS

35

EN

Image 35
Contents Inch Prong are provided for your safety. If the provid Clean only with dry clothDo not install near any heat sources such as Do not defeat the safety purpose of the polarDealer Purchase from PrecautionsImportant Safety Instructions / Precautions # CautionChip Supplied AccessoriesFeatures DTV/TV/CATVContents About Pixel Defects Functions Remote CONTROL, Control and Rear Panel FunctionInput SELECT/ENTER About Interference to Infrared DevicesFunctions Installing the BatteriesRemote Control Range Battery PrecautionsConnection to CABLE/SATELLITE BOX Preparation for USE ConnectionAntenna Cable Connection Hdmi Connecting Other DevicesVideo Cable Connection Component Cable ConnectionDigital Audio Connection For USEPreparation Video ConnectionAnalog Audio Connection Connecting the Power CableAutoscan will start automatically Initial Settings Initial SetupInitial Settings Select source of ANT. in jack using K/L, press EnterPress Enter Channel Settings AutoscanFor TV channels, using K / L , select Air For Catv channels, select CableManual Register To exit the setup, press SetupSelect Register with Enter To exit the setup, press Setup Channel ListAntenna Displays signal strength for each channelAntenna Confirmation Detailil Setting the Panel SaverLanguage Selection LanguageAtsc Volume AdjustmentWatching TV Channel Selection NtscWatching TV Still ModeSelecting Audio Channels Accessing External Devices Wide SidebarFull CinemaBuffy Vampire i Slayer l Screen InformationTo clear the display, press Back or Info again Refer to Language Selection on Sleep TimerOptional Settings Setup Screen Watching TV / Optional SettingsPicture Adjustment CC2, CC4, Text2 and Text4 Caption Mode CC1 and Text1Closed Caption CC3 and Text3CC Style le DTV Closed Caption Closed Caption StyleEnter to confirm Closed l CaptionOptional Settings Use the Number buttons and enter the 4-digit number Using K / L , select V-chipPassword entry screen is displayed ChipTV-MA Mature audience only TV-14 SelectionNC-17 PG-13Set the method of sound input for Hdmi jack Chipip Enter password Confirm passwordHdmi Audio Sold Separately Optional Settings / Attaching a Wall Mount BracketAttaching a Wall Mount Bracket Sold Separately Miscellaneous Troubleshooting Guide Miscellaneous Logue Captions are delayed behind the diaDepending on the screen ContentsGlossary MaintenanceCatv SpecificationsMiscellaneous / Specifications VHF UHFLimits and Exclusions Warranty Statement Regarding NON Authorized RepairsDuration Plasma Display TV rear side Video or Video Connection2AUDIO Output Connection 1ANTENNA 3HDMI Connection 4COMPONENT ConnectionPlasma Display TV side view VCR