Parts and their functions
Video output connectors [VIDEO1, VIDEO2]
The video signals from the camera after cable compensation are output from these connectors. (The same signal is output from connectors 1 and 2.) Connect the connectors to the video input connectors on the live switcher, color monitor, VTR or other device. (Output impedance: 75 ohms)
SYNC output connector [SYNC]
The composite sync signal is output from this connector. Connect the connector to the
(Output impedance: 75 ohms)
RGB/Y, PR and PB/YC output connectors [R/PR/C, G/Y/Y, B/PB]
If a camera such as the
The RGB/Y, PR or PB/YC signals are selected using the camera’s menu. (For details, refer to the camera’s operating instructions.)
S-Video output connector [S-VIDEO OUT] (4-pin S-connector)
The same signals as the ones output from the R/PR/C and G/Y/Y connectors among the RGB/Y, PR and PB/YC output connectors are output from this connector. (Output impedance: 75 ohms)
The YC signals are selected using the camera’s menu, and connected to a color monitor or other device equipped with an
Note:
When the RGB/Y, PR and PB/YC output connectors and
Therefore, use either connectors or connector in line with the connectors used on the device connected to the remote control unit.
Tally/intercom input/output connector [TALLY/INCOM]
Connect this to the TALLY & INCOM connector on the live switcher
Set the INCOM selector switch on the live switcher
When inputting the tally control signals from another device, input them with 0V for ON and open for OFF.
Pin No. | Signal Name |
1 | TALLY |
6 | INCOM MIC |
7 | INCOM GND |
8 | INCOM SP |
11 | TALLY GND |
Fuse holder [FUSE]
Fuse used: HT1.6AN5 (AC 250 V, 1.6 A)
AC power socket [AC IN]
Attach one end of the power cord provided to this socket and the other end to the AC 120V (60 Hz) power supply.
12