Sony KD-30XS955, KD-32XS945, KD-34SX955, KD-36SX955 manual Programming the Remote Control

Programming the Remote Control

If you have video equipment other than Sony brand (or if you have a Sony DVD/VCR combination unit) that you want to control with the TV’s remote control, use the following procedure to program the remote control.

✍ The equipment must have infrared (IR) remote capability in order to be used

		with the remote control.
	1	Turn to the list of “Manufacturer’s Codes” on page 50, and find
		the three-digit code number for the manufacturer of your
		equipment. (If more than one code number is listed, use the
		number listed first.)
	2	Press CODE SET.
	3	Press the VCR/DVD FUNCTION or SAT/CABLE FUNCTION button.
	4	Using the 0-9buttons, enter the three-digit manufacturer’s code
		number.
	5	Press the ENTER button.
		✍ You must do step 5 within 10 seconds of step 4, or you must redo
		steps 2 through 5.
	6
		To check if the code number works, aim the TV’s remote control
		at the equipment and press the POWER button that corresponds
		with that equipment. If it responds, you are done. If not, try using
		another code listed for that manufacturer.
Notes	❑	If more than one code number is listed, try entering them one by
		one until you come to the correct code for your equipment.

❑ If you enter a new code number, the code number you previously entered at that setting is erased.

❑ In some cases, you may not be able to operate your equipment with the supplied remote control. In such cases, use the equipment’s own remote control.

❑ Whenever you remove the batteries to replace them, the code numbers may revert to the factory setting and must be reprogrammed.

Remote Control SETUP

SETUP

49