Sony KD-34XBR970 manual Setting Up the Channel List, Using Initial Setup

Setting Up the Channel List

Setup

SETUP

Using Initial Setup

zFor more details on using Tilt Correction and Vertical Correction, see pages 45-46.

zTo exit the Tilt Correction and Vertical Correction screens, press the MENU button.

After you finish connecting the TV, you need to run the Initial Setup feature, which automatically creates a list of available analog and digital channels and lets you correct tilt and vertical correction settings. The Initial Setup screens appear when you turn on your TV for the first time after hooking it up.

To run Initial Setup

1Press POWER to turn on the TV. The Initial Setup screen appears.

Using the remote control, move the highlight to the desired

language, then press to select that language. The Tilt Correction screen appears.

2Press B b to correct any tilt of the picture. You can choose a

correction between +7 and -7. When finished, press .

3The Vertical Correction screen appears. Press V v to make a vertical correction to the picture. You can choose a correction

between +5 and -5. When finished, press .

4The next screen instructs you to connect your cable/antenna. Check that you’ve connected your signal source correctly.

To start Auto Program, highlight Yes and then press . Auto Program automatically creates a list of receivable analog and digital channels. Auto Program may take 50 minutes or more to complete. A progress bar is displayed while the channel list is being created.

When Auto Program is finished, the lowest numbered channel is displayed.

To run Auto Program again at a later time

❑Use the Auto Program feature as described on page 40.

To add individual digital channels

❑Use the Digital Channel feature as described on page 40.

To reset the TV to factory settings

1Press POWER to turn on the TV.

2Hold down RESET on the remote control.

3Press TV POWER on the TV. (The TV will turn itself off, then back on).

4Release RESET.

20