The message [3D signal has been detected] automatically appears when 3D signal is detected.
Deactivate the [3D Signal Notification] setting. Press HOME, then select 
→ [Picture & Display] → [3D Settings] → [3D Signal Notification] → [Off].
3D Glasses do not fit properly.
(The following adjustments apply only to TDG-BR100.)
Set both the switches on either side for a comfortable fit. Close the temple arms slightly inwards to set the switch. (
)
Bend (adjust) the temple frames for a comfortable fit. (
) 
Adjust the nose pad for your nose. (
)
LED indicator on the 3D Glasses flashes.
(The following illustration shows TDG-BR100.)
Flashes every few seconds: Indicates the glasses are powered on.
Flashes 3 times: Indicates the glasses have been powered off. The glasses turn off if you hold the power button down for 2 seconds, or if no signal from the 3D Sync Transmitter is detected for more than 5 minutes.
Flashes 3 times every 3 seconds: Indicates the battery capacity is almost running out. Replace the battery, or charge the battery if the 3D Glasses have a rechargeable battery.
LED Indicator
You cannot turn the 3D Glasses on.
Replace the battery. (Applies only to
1.Open the battery cover using a coin, etc.
2.Push the edge of the battery and remove it at an angle.
3.Insert a battery (CR2032) with its positive (+) side facing up.
4.Close the battery cover using a coin, etc.
5.Make sure the cover is closed.
Battery (CR2032)
Coin, etc.
When opening or closing the battery cover, be sure to insert a coin, etc., into the slot.
98